Scribd
Upload
105 views2 pages

M SR 0008 PDF

1) The document provides instructions for removing the tilt steering column on a Lexus IS300/IS200. 2) The first steps include removing the steering wheel pad, steering wheel, front door scuff plate, cowl side trim board, lower finish panel, cluster finish panel, column covers, and combination switch. 3) Further steps include disconnecting the sliding yoke, removing the steering column assembly, sliding yoke, and No. 2 intermediate shaft assembly. Matchmarks should be made between removed parts and their mounting locations.

Uploaded by

Moh DeBr
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
105 views2 pages

M SR 0008 PDF

1) The document provides instructions for removing the tilt steering column on a Lexus IS300/IS200. 2) The first steps include removing the steering wheel pad, steering wheel, front door scuff plate, cowl side trim board, lower finish panel, cluster finish panel, column covers, and combination switch. 3) Further steps include disconnecting the sliding yoke, removing the steering column assembly, sliding yoke, and No. 2 intermediate shaft assembly. Matchmarks should be made between removed parts and their mounting locations.

Uploaded by

Moh DeBr
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

SR−8

STEERING − TILT STEERING COLUMN


SR1HH−01

Torx Screw Screw Case REMOVAL


1. REMOVE STEERING WHEEL PAD
NOTICE:
If the airbag connector is disconnected with the ignition
switch at ON or ACC, DTCs will be recorded.
(a) Place the front wheels facing straight ahead.
(b) Using a torx socket wrench, loosen the 2 torx screws until
the groove along the screw circumference catches on the
F07473
screw case.

(c) Pull out the wheel pad from the steering wheel and dis-
connect the airbag connector.
CAUTION:
S When storing the wheel pad, keep the upper surface
of the pad facing upward.
S Never disassemble the wheel pad.
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.

Airbag Connector
Correct Wrong

F07474

Matchmarks 2. REMOVE STEERING WHEEL


(a) Disconnect the connector.
(b) Remove the steering wheel set nut.
(c) Place matchmarks on the steering wheel and main shaft
assembly.
(d) Using SST, remove the wheel.
SST 09950−50013 (09951−05010, 09952−05010,
09953−05020, 09954−05021)
SST F07475 3. REMOVE FRONT DOOR INSIDE SCUFF PLATE AND
COWL SIDE TRIM BOARD
(a) Remove the front door inside scuff plate.
(b) Remove the clip and cowl side trim board.
4. REMOVE LOWER FINISH PANEL
(a) Remove the 3 screws.
(b) Disconnect the connectors and remove the lower finish
panel.
(c) Disconnect the hood lock control cable.

LEXUS IS300/IS200 SUP (RM870E)


SR−9
STEERING − TILT STEERING COLUMN

5. REMOVE CLUSTER FINISH PANEL


(a) Remove the 2 screws.
(b) Disconnect the connector and remove the cluster finish
panel.
6. REMOVE COLUMN UPPER AND LOWER COVERS
(a) Remove the 3 screws and column lower cover.
(b) Remove the column upper cover.
7. REMOVE COMBINATION SWITCH WITH SPIRAL
CABLE
(a) Disconnect the connectors.
(b) Disconnect the airbag connector.
(c) Remove the 3 screws and combination switch.
8. REMOVE SPIRAL CABLE
NOTICE:
Do not disassemble the cable or apply oil to it.

RHD: 9. DISCONNECT SLIDING YOKE


A (a) Place matchmarks on the sliding yoke and control valve
shaft.
(b) Loosen the bolt A and remove the bolt B.
Matchmarks
B 10. REMOVE STEERING COLUMN ASSEMBLY
(a) Loosen the clamp.
(b) Disconnect the connectors.
(c) Remove the 4 nuts and steering column assembly.
11. REMOVE SLIDING YOKE
Remove the bolt A and sliding yoke.
LHD:

Matchmarks
B

F07477

12. REMOVE NO. 2 INTERMEDIATE SHAFT ASSEMBLY


Matchmarks (a) Place matchmarks on the No. 2 intermediate shaft as-
sembly and main shaft.
(b) Remove the bolt and No. 2 intermediate shaft assembly.

F07478

LEXUS IS300/IS200 SUP (RM870E)

You might also like