(Approved) DMS-3 Reprograming PDF
Uploaded by
Irul Umam(Approved) DMS-3 Reprograming PDF
Uploaded by
Irul UmamDMS-3 Reprogramming
p g g Procedure
*Program Download
https://ap1.salesforce.com/sfc/#version?selectedDocumentId=06990000001aveN
1 * 1-1. In case that DMS connection cable has toggle switch as a picture
below,
a Connect adapter to machine.
b Connect adapter to computer.
b
a
c
c Turn on the toggle switch. Then c
EPOS turns into “downloading
mode”(In order to stop sending ON
the electronic signal).
OFF
1
DMS-3 Reprogramming
p g g Procedure
1 * 1-2. In case that DMS connection cable doesn’t have toggle switch,
a Locate EPOS at the back of seat. a
b Open the plate. b
2
DMS-3 Reprogramming
p g g Procedure
1 * 1-2. In case that DMS connection cable doesn’t have toggle switch,
c Remove bolts(6EA) on c
EPOS cover.
d Find DIP switch of marked d
location.
T
Turn th 1st switch.
on the it h
ON
OFF
3
DMS-3 Reprogramming
p g g Procedure
11
2 Execute DMS-3 program
4
Select “Tools” tap, then click
“Download Program”.
5
3 Enter password [11830].
6
4 Once Firmware update pops up,
click “Program” button.
Please check the port number is
correct,
t before
b f click.
li k
4
DMS-3 Reprogramming
p g g Procedure
5 In order to delete old version of
EPOS program, select
"DX_Clear.hex" that is saved
at the step #1 of this instruction 7
and open the file.
6 Key Off & Key On 8
Then, DMS shows programming
status
status.
Once update is completed, Click 9
7
OK and Key Off
“OK” Off.
5
DMS-3 Reprogramming
p g g Procedure
8
*1-1. In case that DMS connection cable has toggle switch,
a Turn off the toggle switch 10
b To begin the installation of new
version of software, turn on the
key.
9 * 1-2. In case that DMS connection cable doesn’t have toggle switch,
19 10
a Turn the DIP switch off
b To begin the installation of new
version of software, turn on the
1st switch.
6
DMS-3 Reprogramming
p g g Procedure
11
10 Execute DMS-3 program
Select “Tools” tap, then click
“Download Program”.
12
11 Enter password [11830].
13
12 Once Firmware update pops up,
click “Program” button.
Please check the port number is
correct before click.
correct, click
7
DMS-3 Reprogramming
p g g Procedure
13 In order to install the new version
of EPOS program,
select “EPOS Program " that is
saved at the step #1 of this
14
instruction and open the file.
14
14 Key Off & Key On 15
Then, DMS shows programming
status. .
15 Once update is completed, Click 16
“OK” Button and Key Off.
8
DMS-3 Reprogramming
p g g Procedure
16 *1-1. In case that DMS connection cable has toggle switch as a picture
below,
Turn the toggle switch off and 17
a
turn on E/G & Check Machine.
Machine
16 * 1-2. In case that DMS connection cable doesn’t have toggle switch,
a Turn the EPOS DIP switch off 17
and
d turn
t on E/G & Check
Ch k
Machine.
