PHYSICS-13-08 - 11th (PQRS) Space

Download as pdf or txt
Download as pdf or txt
You are on page 1of 23

REVIEW TEST-3

P
H YS
ICS
Class : XI (PQRS)
Time : 100 min Max. Marks : 75
INSTRUCTIONS
General Remarks:
1. The question paper contain 10 questions and 20 pages. All questions are compulsory.
2. Write your answer(s) in the space given at the end of each question. Otherwise Marks will not
be awarded.
3. Each question should be done only in the space provided for it, otherwise the solution will not be
checked.
4. Use of Calculator, Log table and Mobile is not permitted.
5. Legibility and clarity in answering the question will be appreciated.
6. Put a cross ( × ) on the rough work done by you.

Name ________________________________ Father's Name ____________________________

Class : __________ Batch : B.C. Roll No. ___________

Invigilator's Full Name __________________________________________________

For Office Use ……………………………. Total Marks Obtained…………………

Q.No 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Marks
Take g = 10 m/s2 where ever required in this paper.

Q.1 Answer following short questions (Show all important steps involved):

(i) If the extension of the spring in figure 1 is x 1 and in figure 2 is x2, the
systems being in constant acceleration, then find the ratio x1/x2. Pulley
and strings are ideal. [2]

Ans. _____________

(ii) Consider the two configurations shown in equilibrium. Find ratio of TA/TB. (Ignore the mass of the rope
and the pulley) [2]

Ans. _____________
(iii) Four identical 2 kg blocks are in equilibrium as shown. All surfaces are
rough. A force of 10 N is applied to block C parallel to incline as shown.
Rank the NORMAL on the BOTTOM surface of each block?
[2]

Ans. _____________________________________
(iv) Find the acceleration of the blocks. [2]

(i) (ii)

Ans. (i) ______________ (ii)__________________


(v) Four identical balls of mass m are arranged as shown. The mass of the block in figure (3) is 4 m and
having acceleration a, the angle of the incline is =30° in figure (2) and all the surfaces are frictionless.
Rank the TENSIONS in the labelled ropes (from lower to higher)? Consider wedge and table to be
fixed. [2]

(1) (2) (3)

Ans. ___________________________________________________________________________
Q.2 Answer following short questions:

(i) Two blocks of masses M1 and M2 are connected to each other through a light
spring as shown in the figure. If we push mass M1 with a force F and
cause acceleration a1 in it, what will be the acceleration of M2? [3]
(Assume friction less surface everywhere).

Ans. _____________________________________

(ii) A particle of mass 10 kg is acted upon by a force F along the line of


motion which varies as shown in the figure. The initial velocity of the
particle is 10 ms–1. Find the maximum velocity attained by the
particle before it comes to instantaneous rest. [3]

Ans. _____________________________________
(iii) For the given system of blocks, massless and frictionless pulley,
and ideal strings.
(a) Find the minimum coefficient of friction (min) for which the system
stays in equilibrium.
(b) If  = min/2 find the acceleration of the system, tensions in string
A and B.
[1+2]

Ans.(a)min = ____________ (b) a = ____________; TA = ____________; TB = _____________


(iv) If Block B comes to rest instantaneously after striking the ground,
find the time taken by the block A to strike the pulley.
(Assume friction less surface everywhere).
[3]

Ans. ____________
(v) Two blocks A & B are kept on a partically rough surface.
Two forces F1 & F2 act as shown on blocks A & B
respectively. Find the acceleration of the system & friction
force of block A.(with direction)

[2+1]

Ans.
acceleration = ___________

friction = ______________
(vi) An aeroplane A is flying horizontally due east at a speed of 400 km/hr.
Passengers in A, observe another aeroplane B moving perpendicular to
direction of motion at A. Aeroplane B is actually moving in a direction 30°
north of east in the same horizontal plane as shown in
the figure. Determine the velocity of B. [3]

Ans. _____________________________________
Q.3 Krrish is saving a child in a building caught by fire. He and child are trapped and he ties a rope and drops
it out of window. Unfortunately, the tensile strength of the rope is 900 N and Krrish & child's combine
mass is 100 kilograms. He therefore decides to let the rope slide through his hands, pulling just hard
enough on it so it doesn't break. What will be his speed at the bottom of the rope as he hits the ground?
Assume the rope is 12 meters long and that Krrish's vertical speed is zero as he leaves the window at the
top of the rope. [3]

Ans. _____________________________________
Q.4 A small cubical block is placed on a triangular block M so that they touch each
other along a smooth inclined contact plane as shown. The inclined surface
makes an angle  with the horizontal. A horizontal force F is to be applied on the
block m so that the two bodies move without slipping against each other.
Assuming the floor to be smooth also, determine the
(a) normal force with which m and M press against each other and
(b) the magnitude of external force F. Express your answers in terms of m, M,  and g. [3+3]
Ans. Normal = ____________________________ F = ___________________________________
Q.5 The system shown in the figure is in equilibrium. Find the initial acceleration of
A, B and C just after the spring-2 is cut. [2+2+2]

Ans. acc. of A ________________ ; acc. of B ________________ ; acc. of C ________________


Q.6 A truck undergoes constant acceleration, a = 5 m/s2. On the back of truck a two-sided, frictionless ramp
is fixed, with each side of the ramp at an angle  from the horizontal. Two masses, m1 and m2, sit on
either side of the ramp as shown, connected by a massless string wound over a massless pulley.
(a) Draw free body diagram (FBD) of m1 & m2 in ground frame.
(b) Calculate the ratio of masses, m2/m1, for which the masses do not slide on the ramp when released.
[3+3]

PART (a)

FBD of A FBD of B

PART (b)
Ans. ________________________________
Q.7 A time - dependent force, F = 10t, starts to act on a block of mass 5 kg at
t = 0 as shown in the figure.
(i) When does it lose contact with the ground?
(ii) Draw the a – t graph for 0-10 seconds.
(iii) Find the speed of the block at t = 10 sec. [2 + 3 + 1]
Ans.

(i) It looses contact at t = _______________ (ii)

(iii) v = ______________
Q.8 A block with mass m is pushed along a horizontal floor by a force P that makes an angle with the
horizontal as shown. The coefficients of kinetic and static friction between the block and the floor are k
and s, respectively.
(a) Find the maximum force that can be applied without moving the block.
(b) The applied force P is larger than the maximum force calculated in (a). As a
consequence, the block will start to move. Find the acceleration of the block.
[3+3]
Ans. Fmax = ____________________________

a = _____________________________
Q.9 The system shown in the figure is connected by flexible inextensible cord.The
coefficient of friction between block C & the rigid surface is 0.3. The system
starts from rest when height of block A above ground is d.
Pulley and strings are ideal.
(a) Find velocity of C just before A is going to touch ground in terms of d and the
other given values.
(b) Find acceleration of B after A touches the ground and comes to rest
instantaneously.
(c) Find the initial distance 'd' between A and the ground, so that the system comes
to rest when body B just touches A. [3+2+2]
Ans. (a) Vc = _________________ (b) aB = _________________ (c) d = _________________
Q.10 An aircraft is flying horizontally with a constant velocity = 200 m/s, at a
height = 1 km above the ground. At the moment shown, a bomb is
released from the aircraft and the cannon-gun below fires a shell with
initial speed 200 m/s, at some angle .
(a) For what value of '' will the projectile shell destroy the bomb in mid-air?
(b) If the value of  is 53°, find the minimum distance between the bomb
and the shell as they fly past each other. Take sin 53° = 4/5.
[3+4]
Ans. (a)  = _________________ (b) dmin= _________________

You might also like