Scribd Logo
Upload

Welcome to Scribd!

  • 331 views

    Sop For Bop Accumulator

    Uploaded by

    arunpt123
    This document outlines the standard operating procedure for a blowout preventer (BOP) accumulator. It lists 15 steps to ensure the accumulator is properly set up and tested, including checking oil levels, connections for air, power, and outlets; inspecting for leaks; verifying ram valve positions; checking fire equipment; starting and pressurizing the accumulator; operating outlet rams; bleeding pressure lines; and shutting down in case of issues.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    Sop For Bop Accumulator

    Uploaded by

    arunpt123
    331 views1 page
    This document outlines the standard operating procedure for a blowout preventer (BOP) accumulator. It lists 15 steps to ensure the accumulator is properly set up and tested, including checking oil levels, connections for air, power, and outlets; inspecting for leaks; verifying ram valve positions; checking fire equipment; starting and pressurizing the accumulator; operating outlet rams; bleeding pressure lines; and shutting down in case of issues.

    Original Title

    SOP FOR BOP ACCUMULATOR

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This document outlines the standard operating procedure for a blowout preventer (BOP) accumulator. It lists 15 steps to ensure the accumulator is properly set up and tested, including checking oil levels, connections for air, power, and outlets; inspecting for leaks; verifying ram valve positions; checking fire equipment; starting and pressurizing the accumulator; operating outlet rams; bleeding pressure lines; and shutting down in case of issues.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    331 views1 page

    Sop For Bop Accumulator

    Uploaded by

    arunpt123
    This document outlines the standard operating procedure for a blowout preventer (BOP) accumulator. It lists 15 steps to ensure the accumulator is properly set up and tested, including checking oil levels, connections for air, power, and outlets; inspecting for leaks; verifying ram valve positions; checking fire equipment; starting and pressurizing the accumulator; operating outlet rams; bleeding pressure lines; and shutting down in case of issues.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    of 1

    SOP FOR BOP ACCUMULATOR

    1. Ensure sufficient level of Servo System oil in the accumulator tank


    provided.
    2. Ensure both drive air source (8-10 KCM) and electric drive motor
    connections have been made.
    3. Ensure Outlet connections have been made.
    4. Ensure Proper earthing of the accumulator unit
    5. Check if there is any leakage and if found should be arrested
    6. Ensure that all the RAM valves are in fully open position.
    7. Check whether there are sufficient firefighting equipment provided
    8. Ensure Connections of derrick floor console panel and remote control panel
    of accumulator.
    9. Start the BOP Accumulator.
    10. Observe the Pressure.
    11. Gradually operate Required Outlet Ram valve.
    12. After Completion of operation, bleed the outlet pressure line till the
    pressure gauge get zero.
    13. Stay away outlet pressurised lines
    14. Do not open outlet pressure line till bleeding has been finished.
    15. If any discrepancy then immediately turn off the Accumulator.

    You might also like