Aalborg EH: Versatile Booster, Auxiliary Oil and Water Heater

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

Aalborg EH

Versatile booster, auxiliary oil and water heater

The Aalborg EH is a flow-through electrical heater, ideal


for heating of oil or water. Its heat load capacities range
from 3 to 235 kW, with design conditions up to 16 bar(g)
and 160°C. The standard Aalborg EH can be mounted
both vertically and horizontally, but is also available as an
outflow suction heater or tank-mounted immersion heater.

The Aalborg EH is approved by all major marine classifica-


tion societies and is CE/PED approved.
• Access points: Electric power supply terminals • Installation: Vertical or horizontal
(110-690 V AC/DC), the safety thermostat and
• Surface loads:
the optional control thermostat are located on
- Lubrication oil: 1 W/cm2
the top hood.
- Heavy fuel oil: 1.4 W/cm2
- Water: 3 W/cm2
• Design pressure: 16 bar(g) [EH40-15 bar(G)]
• Accessories (optional):
• Design temperature: 160°C - Safety valve
- Drain valve
• Flanges: PN 16 DIN 8630, JIS 16K or EN1092-1
- Pressure gauge
- Thermometer
- Pt100 sensor

Standard product range


Dimensions

Type EH-15 EH-20 EH-25 EH-30 EH-35 EH-40


No. of elements 9 18 27 30 27 30 42 39 42 39 42 54 51 54 51 54 66 69 63 66 69
Flange size DN DN 25, 30, 40 DN 25, 32, 40, 50, 65 DN 32, 40, 50 DN 40, 50, 65, 80 DN 40, 50, 65, 80
Element length 600 850 1000 850 850 1000 850 850 1000 1000 850 1000 1000 1200 1200 1000 1200 1200 1500 1500 1500 1500 1800 1800 1800
A 200 250 250 250 250 300
B 220 220 220 220 300 300
C 270 280 280 280 350 350
E 420 670 820 670 670 820 670 670 820 820 670 820 820 1020 10220 820 1020 1020 1320 1320 1300 1300 1600 1600 1600
F 891 1141 1291 1137 1137 1287 1142 1142 1292 1292 1152 1302 1302 1502 1502 1309 1509 1509 1809 1809 1814 1814 2114 2114 2114
I 254 280 307 332 348 373
J 327 322 337 342 347 363
K 280 530 680 530 530 680 530 530 680 680 530 680 980 1020 1020 680 880 880 1180 1180 1160 1160 1460 1460 1460
ØD incl. insulation ø270 ø324.5 ø380 ø425 ø460 ø510
O 255 275 300 335 380 400
Net weight (kg) 55 65 71 102 109 112 137 140 163 166 206 225 228 254 258 294 327 331 381 386 486 495 555 560 565

Dimensions in mm. For guidance only. A dimensional drawing will be made upon request.

Standard product range


Capacities (kW)

Type EH-15 EH-20 EH-25 EH-30 EH-35 EH-40


Lube oil 5 7 8.5 12 14 17 21 23 26 29 33 37 40 45 48 51 59 63 74 78 96 100 111 116 121
Fuel oil 7 10 12 17 20 24 30 33 36 40 47 52 56 63 68 72 83 88 104 110 135 141 156 164 171
Water 15 21 26 36 42 51 64 70 77 85 101 111 120 135 146 154 178 188 223 235 See special data sheet
Electronic thermostat Pt100 Server

The Alfa Laval Aalborg thermostat type TC-E 8/4 is an


1
2
3

Binding screws 2 and 3 short circuit.


Connect Pt100 to binding screws 1 and 2. Supply
If 2-wire Pt100 sensor:
electronic P-controller for use with electrical heaters.
Programming

The thermostat is based on a Pt100 sensor mounted in


the electric heater and operates the up to 8 individual
power relays.
Zero 4
Phase 5

The desired outlet temperature is programmed into the (Ground) 6

unit and the actual temperature is indicated on the display. Relay 1


8
9
22
21
Relay 8

Fluctuations in flow will result in changes in the measured Relay 2


10
11
20
19
Relay 7

12 18
temperature and thus the signal to the controller, which Relay 3
13
14
17
16
Relay 6

Relay 4 Relay 5
in turn will engage or disengage heating elements in the 15 15

electrical heater.

The thermostat is very accurate and is used in applications


where it is essential to maintain a constant temperature at
all times.

Ordering key
Number of steps Size in mm (L x W x H) Supply Enclosure
Part No. 56L1001 1 115 x 110 x 70 1 x 220/240 V - 50/60 Hz IP65
Part No. 60T3006 2 100 x 100 x 80 1 x 220/240 V - 50/60 Hz IP54
Part No. 56L1030 3, 4, 5, 6, 7 & 8 200 x 120 x 80 1 x 220/240 V - 50/60 Hz IP56

Main technical data


60T3006 56L1030
Mechanical Electronic
2 steps 3, 4, 5, 6, 7 & 8 steps
Range (°C) +20 – +150 0 – +200
Ambient temp. (°C) -20 – +70 -20 – +60
Hysteresis (°C) +3.0 +2.0
Min- temp. between each step (°C) +1.5 +1.0
Supply max. (volts/amperes) 250 VAC / 10 A 250 VAC / 10 A
Cable entries 1 x PG13.5 1 x PG13.5
Sensor Thermostatic expansion in Cu probe 1 x Pt100 in stainless steel

Control panel for Aalborg heaters with lamps that indicate stepwise regulation

Control panel for the Aalborg EH electrical heater Control panel for the Aalborg EH-S heater

This document and its contents are subject to copyrights and other intellectual property rights owned by Alfa Laval AB (publ) or any of its affiliates (jointly “Alfa Laval”). No part of this document
may be copied, re-produced or transmitted in any form or by any means, or for any purpose, without Alfa Laval’s prior express written permission. Information and services provided in this
document are made as a benefit and service to the user, and no representations or warranties are made about the accuracy or suitability of this information and these services for any purpose.

All rights are reserved.

100009264-1-EN © Alfa Laval Corporate AB

How to contact Alfa Laval


Up-to-date Alfa Laval contact details for all countries are always available on
our website at www.alfalaval.com

You might also like