Scribd
Upload
76 views

Lab 4 Packet Tracer - Implement OSPFv2 Advanced Features

This document provides instructions for configuring OSPFv2 routing between three routers - RA, RB, and RC. Key requirements include configuring OSPFv2 with a process ID of 1 on each router, adjusting OSPF priorities and timers, setting passive interfaces, propagating a default route, and securing updates with MD5 authentication using the key "Area0pa55". The goal is to verify connectivity between the routers and an external web server.

Uploaded by

WING KIN LEUNG
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
76 views

Lab 4 Packet Tracer - Implement OSPFv2 Advanced Features

This document provides instructions for configuring OSPFv2 routing between three routers - RA, RB, and RC. Key requirements include configuring OSPFv2 with a process ID of 1 on each router, adjusting OSPF priorities and timers, setting passive interfaces, propagating a default route, and securing updates with MD5 authentication using the key "Area0pa55". The goal is to verify connectivity between the routers and an external web server.

Uploaded by

WING KIN LEUNG
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Packet Tracer - Implement OSPFv2 Advanced Features

Addressing Table
Device Interface IP Address Subnet Mask

RA G0/0 192.168.1.1 255.255.255.0


RB G0/0 192.168.1.2 255.255.255.0
RC G0/0 192.168.1.3 255.255.255.0

RC
S0/0/0 209.165.200.225 255.255.255.252

Scenario
In this Packet Tracer activity, your focus is OSPFv2 advanced configurations. IP addressing
has been configured for all devices. You will configure OSPFv2 routing with passive
interfaces and default route propagation. You will modify the OSPFv2 configuration by
adjusting the OSPF timers. You will also secure OSPF routing updates with MD5
authentication. Finally, you will verify your configurations and test connectivity between end
devices.

Instructions

Requirements
   Use the following requirements to configure OSPFv2 routing on RA and RB:
o    OSPFv2 routing requirements:
  Process ID 1
  Configure the network address for each interface under OSPF
o    OSPF priority set to 150 on the LAN interface of RA
o    OSPF priority set to 100 on the LAN interface of RB
o    Set the hello interval to 5
o    Set the dead interval to 20
o    Configure MD5 authentication for area 0. Use a key of Area0pa55.
   Use the following requirements to configure RC OSPFv2 routing:
o    OSPFv2 routing requirements:
  Process ID 1
  Network address for the LAN interface
  Set all interfaces to passive by default, but allow OSPF updates on the active LAN
interface
  Set the router to distribute default routes
o    Configure a directly attached default route to the Internet
o    OSPF priority set to 50 on the LAN interface
o    Set the hello interval to 5
o    Set the dead interval to 20
o    Configure MD5 authentication for area 0. Use a key of Area0pa55.
Note: Issue the clear ip ospf process command on RC if the default route does not
propagate.
   Verifyyour configurations and test connectivity
o    OSPF neighbors should be established and routing tables should be complete.
o    RA should be the DR. RB should be the BDR.

o    All three routers should be able to ping the web server.

You might also like