Creaton Pv-Autarq. Solar Roof Tiles Powered by Autarq.: All Benefits at A Glance

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Technical Data

CREATON PV-AUTARQ
(Version 2/2022)

CREATON PV-AUTARQ.
Solar roof tiles powered by Autarq.
Designed, manufactured and refined in Europe.

All benefits at a glance.


Flexible Durable Weatherproof
Solar roof tiles are suitable even Just as reliable as the manu- Tile impermeability and water
for complex roof surfaces facturer’s original roof tiles drainage remain intact

High quality Plug-and-play installation Traditional workflow


Same materials as used in Even without prior electrical Solar tiles and regular tiles are
conventional solar modules knowledge installed at the same time

Fully intact roof Service-friendly


Perfectly ventilated, without High safety and fire protection No electronics on the roof, tiles
drilling or screws Through safe low voltage range can be replaced at any time

Colours

FINESSE black glaze NUANCE black engobe NUANCE copper red engobe
Set yourself free.
Request a non-binding offer.
autarq.com

Technical Data

CREATON PV-AUTARQ CREATON PV-AUTARQ


Electrical Data (STC) FINESSE black glaze & NUANCE black engobe NUANCE copper red engobe

Nominal output power PMPP 10 W 8W

Nominal voltage UMPP 41 V 41 V

Nominal current I MPP 0.245 A 0.195 A

Open circuit voltage UOC 49 V 49 V

Short-circuit current ISC 0.255 A 0.205 A

Temperature coefficient -0.40 %/K -0.40 %/K

Electrical data are average values (+/- 5 %), measured under standard test conditions (STC): 1000 W/m2, 25 °C, AM 1.5 (Reference measurement by Fraunhofer ISE Freiburg, Germany)

Material Data Solar Roof Tiles and Roof

Dimensions 257 x 437 mm Covering capacity 12 tiles/m2

Solar module size 210 x 340 mm


Recommended batten size 40 x 60 mm

Mechanical strength 5400 Pa, hail- and snowproof, walkable


Cover length 352 +/- 2 mm
Exact batten spacing is mandatory
Tile material Clay
Cover width 224–226 mm
Front glass 3.2 mm toughened structured solar glass (ESG)
Weight 4.9 kg
Solar cells Monocrystalline silicon solar cells

Roof pitch 15–80°


Composite materials EVA, polyolefins, silicone

Recommended roofing Off-centre


Connector Proprietary plug system, UV-resistant

Colours FINESSE black glaze, NUANCE black engobe,


Connection cable 2 x 0.75 mm2 solar cable in compliance
NUANCE copper red engobe
with EN50618 H1Z2Z2-K

Operating temperature -40 bis +85 °C Tiles per package Packs of four

For further data on the CREATON PV-AUTARQ tile and installation details, please refer to the original data
sheets and installation manual by CREATON.

Guarantee and Certification

Product warranty 5 years

Performance guarantee 25 years, 80 % electrical power output

Applicable standards IEC 61215, IEC 61730

In partnership with:
Hail resistance class 5 (extra hailproof)

Fire safety Extra low voltage in compliance with


VDE 0100-712

Fire resistance classification


BROOF (t1) – hard roof, not flammable
in compliance with EN 13501-5

Autarq GmbH, Brüssower Allee 87, 17291 Prenzlau, Germany


CREATON GmbH, Dillinger Straße 60, 86637 Wertingen, Germany

www.creaton.de / www.creaton.at / www.creaton.ch / www.autarq.com

Version 2/2022. Technical changes and errors may occur.

You might also like