0% found this document useful (0 votes)
203 views7 pages

Development Standards Summary Table - Corner Lot

This document provides a summary of development standards for construction of new dwelling houses, attached developments, and additions/alterations on corner lots. It includes standards for building width, height, floor area, setbacks from roads and neighboring properties. Standards vary based on the lot size. The summary is intended as guidance and all stated rules and regulations must be complied with for any development.

Uploaded by

Yanbo Gu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
203 views7 pages

Development Standards Summary Table - Corner Lot

This document provides a summary of development standards for construction of new dwelling houses, attached developments, and additions/alterations on corner lots. It includes standards for building width, height, floor area, setbacks from roads and neighboring properties. Standards vary based on the lot size. The summary is intended as guidance and all stated rules and regulations must be complied with for any development.

Uploaded by

Yanbo Gu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Summary of Development Standards

Corner Lot June 2018

This Summary Table is intended as a guide to the development standards for the construction of a new:
• 1-2 storey dwelling house; For further information:
• attached development; and Codes Hotline – 13 77 88
• alterations and additions to dwelling houses and attached development
[email protected]
as complying development on a corner lot in Zones R1, R2, R3, R4 and RU5.

Corner Lot means a lot that has 2 contiguous boundaries with a road or roads that intersect at an angle of 135 degrees
or less (whether or not the lot has any other boundaries with a road).

Important Notes
1. Development standards under the Housing Code are determined by lot area, lot width or a combination of the two.
All standards (reflected in all of the following tables) must be complied with.
2. The area of a corner lot must not be less than 200m2 and the width of a lot must not be less than 6m measured at the
primary road building line.
3. Only 1 dwelling house is permitted on the lot (excluding secondary dwellings).
4. Development standards for excavation, fill, retaining walls and structural supports, drainage, protected tree
requirements and protection of adjoining walls associated with dwelling houses are provided under Division 5.
5. Development standards for dwelling houses on bush fire prone land, flood control lots and land near the Siding Example of a Corner Lot
Springs Observatory are provided under Clauses 3.4, 3.5 and 3.6.
6. This Table must be read with all clauses under the Housing Code.
7. EPI = Environmental Planning Instrument.
8. This Summary Table only applies to Part 3 Housing Code, and does not apply to the Transitional Housing Code or
any other complying development codes.

Disclaimer: The information provided, including Summary Tables, is intended to be general information only and does not constitute professional advice and should not be
relied upon as such. No liability is accepted for reliance on any information that is provided. You should seek independent professional advice and refer to the relevant
legislation, including the State Environmental Planning Policy (Exempt and Complying Development Codes) 2008
(http://www.legislation.nsw.gov.au/#/view/EPI/2008/572) before taking action.

Department of Planning and Environment Page 1 of 7


Summary of Development Standards
Corner Lot

Development Standards for a Corner Lot (based on lot area)


Clause Built Form Lot Area (m2)
Development
200–250 >250–300 >300–350 >350–450 >450–560 >560–600 >600–740 >740–900 >900–920 >920–1000 >1000–1500 >1500
Standards
3.1 (3) Width of the primary road 6m
boundary
3.1 Maximum number of 2
storeys
3.8 Maximum building height 8.5m
3.9 Maximum gross floor 78% 75% 235m2 25% + 290m2 25% + 335m2 25% + 380m2 25% + 400m2 400m2
area (% = percentage of 150m2 150m2 150m2 150m2
lot area) 1
3.10 (1) Minimum If there are Setback average - setback cannot be less than the average primary road setback of the 2 nearest dwelling houses
and (3) primary 2 dwelling
road houses 2
setback within 40m
of lot on
the same
side of the
primary
road
In the 3m 3m 4.5m 4.5m 4.5m 4.5m 4.5m 4.5m 6.5m 6.5m 6.5m 10m
absence of
are 2
dwelling
houses
within 40m
of lot on
the same
side of the
primary
road

1 Please note 1 car parking space is excluded from the calculation of gross floor area.
2 Note that there are certain dwelling houses that are not to be included, such as dwelling houses on battle axe lots. See clause 3.10(2).

Department of Planning and Environment Page 2 of 7


Summary of Development Standards
Corner Lot

Clause Built Form Lot Area (m2)


Development
200–250 >250–300 >300–350 >350–450 >450–560 >560–600 >600–740 >740–900 >900–920 >920–1000 >1000–1500 >1500
Standards
3.10 Minimum secondary road 2m 2m 2m 2m 2m 2m 3m 3m 3m 3m 3m 5m
(11) setback
Refer to 3.14 (7), (8) and
(9) for secondary road
articulation requirements
3.10 Minimum If a As specified by the EPI
(13) setback classified
from road
classified setback is
road specified in
EPI
No setback 9m
specified in
EPI
3.10 Minimum setbacks from 3m
(14) public reserves 3
3.10 Minimum Building
(10) rear Height
setback for 3m 3m 3m 5m 10m
0 - 4.5m 3m 3m 3m 3m 3m 3m 3m
parts of
building
depending >4.5 - Lesser of 8m 8m 8m 8m 8m 8m 8m 8m 8m 12m 15m
on height 8.5m 10m or
at that average
point: of 2
adjoinin
g
Note: dwelling
Exceptions s
to side and measure
rear d at
setbacks 4.5m
apply. See above
clause 3.11 existing

3 Public reserve setback applies to a dwelling house, cabanas, cubby house, garden shed, gazebo, fernery, greenhouse or shed.

Department of Planning and Environment Page 3 of 7


Summary of Development Standards
Corner Lot

Clause Built Form Lot Area (m2)


Development
200–250 >250–300 >300–350 >350–450 >450–560 >560–600 >600–740 >740–900 >900–920 >920–1000 >1000–1500 >1500
Standards
(1), (2), (5) ground
and (7) for level
detail
3.11 (5) Abutting a rear lane: Despite 3.10 (10), the building may be built within 900mm, or abut a rear lane for up to 50% of the length of that boundary
3.12 (1) Maximum Setback
& (2) floor level Not Not 2m 2m 2m 2m 2m 2m 2m 2m 2m 2m
<3m
height of permitted permitted
attached
side or rear 3m – 6m Not Not 3m 3m 3m 3m 3m 3m 3m 3m 3m 3m
balconies, permitted permitted
decks, >6m Not Not 4m 4m 4m 4m 4m 4m 4m 4m 4m 4m
patios, permitted permitted
terraces
and
verandahs
where lot
width 4 is
more than
10m:
3.12 Maximum area of 12m2
(3) attached balconies,
decks, patios, terraces
and verandahs setback
from side or rear within
<6m; and with a floor
level >2m above ground

4 Measured at the building line.

Department of Planning and Environment Page 4 of 7


Summary of Development Standards
Corner Lot

Clause Landscape Lot Area (m2)


Development
200-250 >250-300 >300-350 >350-450 >450-560 >560-600 >600-740 >740-900 >900-920 >920-1000 >1000- >1500
Standards
1500
3.13 (1) Minimum landscaped 10% 10% 15% 15% 20% 20% 30% 30% 40% 40% 40% 45%
& (2) area (% of lot area) 5

Side Setbacks (based on lot width and height of development)

Clause Built Form Development Standards Lot width Height of development Minimum Side setback
nearest to the side setback
3.10 Side setback 6m - 10m 0m – 5.5m 900mm
(4)
>5.5m – 8.5m (Building height – 5.5m) ÷ 4 +
Built to boundary setbacks may apply for lot widths 6-12.5m 0.9m
(see below)
>10m – 18m 0m – 4.5m 900mm

Note: Exceptions to side and rear setbacks apply. See clause >4.5m - 8.5m (Building height – 4.5m) ÷ 4 +
3.11 (1) & (2) for detail 0.9m
>18-24m 0m – 4.5m 1.5m
>4.5m - 8.5m (Building height – 4.5m) ÷ 4 + 1.5
>24m 0m – 8.5m 2.5m

5 Minimum length and width of landscaped area is 1.5m x 1.5m.

Department of Planning and Environment Page 5 of 7


Summary of Development Standards
Corner Lot

Development Standards for a Corner Lot (based on lot width)


Clause Built Form Development Standards Lot Width (at the building line)
6m - 8m >8m -10m >10m - 18m >18m – 24m >24m

3.10 (5) Built to boundary setback may build to 1 side may be built to 1 If lot not wider Not permitted Not permitted
& (6) boundary side boundary than 12.5m may
The development may be built to one side boundaries build to 1 side
boundary
(depending on lot width) if:
a) there is a building wall on the adjoining lot within
900mm of the boundary with no windows, doors or
openings or
b) there is no building wall on the adjoining lot within
900mm of the boundary

See clause 3.10 (7) for maximum height of built to boundary


wall requirements; and clause 3.10 (8) & (9) for maximum
length
3.15 (8) Maximum width of garage doors facing road 3.2m 3.2m If lot not wider 6m 6m
than 12m - 3.2m
If lot >12m - 6m
Clause Amenity Development Standards Lot width (at the building line)
6m - 8m >8m -10m >10m - 18m >18m – 24m >24m

3.14 & Refer to clause 3.14 relating to building design, in particular


3.15 3.14(7) Secondary road frontage for corner lots and 3.15 for
privacy screens requirements for windows, balconies, decks,
patios, terraces and verandahs for additional amenity
requirements
3.16 (1) Car parking space required on lot Not required 1 space required 1 space required 1 space required 1 space required

Note: See clause 3.16 for additional requirements. Please


note exclusion of required car parking from calculation of
gross floor area
3.16 (5) Primary road garage and Dwelling primary road
carport setback setback

Department of Planning and Environment Page 6 of 7


Summary of Development Standards
Corner Lot

Note: See clause 3.16 for <4.5m 5.5m


additional requirements
4.5m or greater 1m or more behind the building line

Landscaping Development Standards


Clause Landscape Development Standards Lot Area (m2)
6m – 8m >8m - 10m >10m -18m >18m – 24m >24m

3.13 (2) Minimum area forward of the building line to 25% of area forward 25% of area forward 25% of area forward 50% of area forward 50% of area forward
& (3) be landscaped6 of building line of building line of building line of building line of building line
3.13 (3) Proportion of required landscaped area that 50%
must be behind the building line
3.13 (4) Minimum area of principal private open space 16m2 16m2 24m2 24m2 24m2

6 Minimum width and length of landscaped is 1.5m x 1.5m.

Department of Planning and Environment Page 7 of 7

You might also like