Scribd
Upload
116 views6 pages

Cdu Preflight Procedure Note - FTD

This 3-sentence summary provides the key steps for a CDU preflight procedure in an FTD: The document outlines the process for entering route information including the airport, gate, route coordinates, and destination into the CDU. It describes activating the route and executing it, then building an alternate route without activating it. Finally, it details entering additional data like wind, flight levels, and temperatures obtained from dispatch.

Uploaded by

Sky Lover
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
116 views6 pages

Cdu Preflight Procedure Note - FTD

This 3-sentence summary provides the key steps for a CDU preflight procedure in an FTD: The document outlines the process for entering route information including the airport, gate, route coordinates, and destination into the CDU. It describes activating the route and executing it, then building an alternate route without activating it. Finally, it details entering additional data like wind, flight levels, and temperatures obtained from dispatch.

Uploaded by

Sky Lover
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

CDU PREFLIGHT PROCEDURE NOTE - FTD

R6

Insert airport REF & GATE ex. OEJN GATE 7 and compair the cordenantes
then use the most accurate.

Activate and execute the route


( After entering the route manually on next page 2/2 )
Then enter
destination o
R3

Ex.OERK

Then enter again


R3 ( boxes )

ACTIVATE ( R6 ) Then 1/2


EXECUTE
RTE COPY
To enter DEST Alternate RTE

Then RTE 2

L6

Change DEST to ALT. Then 2/2


( ex. OEDF )

Build the alternate route after KIA


(ex. To KFA )

DO NOT ACTIVATE
THEN

Change to PLN MODE


to have “STEP” ON R6

To go through all
Press R6 points
Then enter constraint on KIA on R5
( ex. 210/6000 )

THEN
Select MAP MODE
back again to hav
“RTE DATA” ON R6

To insert
Press R6 wind data

Pick a point

And enter th
desire FL as per
FLT PLN
e

On L1
( ex. FL310 )

Enter the data on You can enter up


R4 & R5 to 4 flight levels

Then
Check DEST

Then previous page


4/4

Delete L1 & R1 to change


from M to P
And enter All needed data
Press R6

Press R6
Enter SEL TEMP given by OPT
on L1

Enter al
neede
dat
( wind , .. )
l

Enter data
a

obtaine
from OPT

Captain will enter ZFW & CG


d

DISCLAIMER : THIS DOCUMENT IS A


F/O. Mohiaddin M. Banjar
PERSONAL NOTE AND FOR TRAINING
PURPOSE ONLY. 21-05

You might also like