Scribd
Upload
52 views1 page

WP 26

The document describes the steps to modify the administrator password for software, which includes entering the old password, new password, and retyping the new password to confirm it. The new password must be at least 6 digits. It also explains how to configure SMS settings to receive alarm notifications via mobile phone by entering phone numbers and selecting the communication port and baud rate. Event receiving lists are configured separately in the Event Action page.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
52 views1 page

WP 26

The document describes the steps to modify the administrator password for software, which includes entering the old password, new password, and retyping the new password to confirm it. The new password must be at least 6 digits. It also explains how to configure SMS settings to receive alarm notifications via mobile phone by entering phone numbers and selecting the communication port and baud rate. Event receiving lists are configured separately in the Event Action page.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Diagram 4-4

Step 2 Enter old password, new password and re-type new password to confirm new
password. The new password should be at least 6 digits. Then, click “Apply”
button to successfully modify password for administrator.
NOTE1: Simply click “Login” button on the top right corner to log in the software.
NOTE2: If password is forgotten, it’s necessary to re-install the software.
4.1.3.SMS Setting
It’s to enter SMS receiver list. In the event of an alarm occurring, a message about
inverter status will be sent to the specified users via mobile phone. For the event
receiving list, please configure in “Event Action” page (refer to section 4.1.5).

Step 1 Choose WatchPower Configuration >> SMS Setting. Refer to Diagram 4-5.

Diagram 4-5

Step 2 Select communication port and baud rate.

Step 3 Enter mobile phone numbers in “Phone no.” column and click “Add” button to

 

You might also like