Scribd
Upload
39 views1 page

WP 19

The document discusses how to change passwords for SNMP devices in three steps: select the devices, enter the original password and new password twice to confirm, and click "Apply" to change the passwords for all selected devices. Passwords must be between 8-15 digits and all devices' passwords will be updated to the new password. The document also mentions how to configure two static trap addresses and the trap port number in the SNMP manager, which defaults to port 162. Trap addresses can be static or dynamically assigned by the monitoring software.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views1 page

WP 19

The document discusses how to change passwords for SNMP devices in three steps: select the devices, enter the original password and new password twice to confirm, and click "Apply" to change the passwords for all selected devices. Passwords must be between 8-15 digits and all devices' passwords will be updated to the new password. The document also mentions how to configure two static trap addresses and the trap port number in the SNMP manager, which defaults to port 162. Trap addresses can be static or dynamically assigned by the monitoring software.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

list.

z Select all: Choose to change passwords for all SNMP devices on the window list

Enter original password, new password and re-enter new password to confirm. Then, click

“Apply” button to apply password change.

NOTE: The length of password is 8~15 digits. If this password change is applied for all

SNMP devices, all SNMP devices passwords must be consistent.

Static trap address

You may configure two static trap addresses and change trap port in SNMP Manager. The

default trap port is 162. Refer to Diagram 3-25.

Diagram 3-25

NOTE: The SNMP device could provide 2 static trap addresses and 8 dynamic trap

addresses. The SNMP device will automatically obtain IP address of host machine which

installed monitoring software as dynamic trap address. If one of dynamic trap address is

inactive for over 10 minutes, SNMP device will automatically release it and obtain a new

dynamic trap address.

3.4.2.3. Language

SNMP Manager offers 12 languages:

¥ Chinese(Simplified)

¥ Chinese(Traditional)

 

You might also like