BleDoubleN1 Bleaching System 100tmdia

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

DoublePass Bleaching System

Adsorbent
Filters

To
Carbon vacuum

Water

Bleaching
Earth
DoublePass Bleaching System

Silica To
vacuum
Polish
Filters

Filter
Bleacher Aid
Slurry
Tank Filtrate
Dryer Receiver To storage or
Bleaching deodorizing
Mix Heater
Tank Precoat
Storage
Tank
Cooler
Drying
Heater
Feed
Heater

From
neutralizing

Feed
Economizer

From
PROCESS BASICS
storage
Silica Pre-treatment: The incoming degummed or neutralized
oil is mixed with a special silica designed to adsorb soaps and
phospholipids (gums). The treated oil is dried and filtered (1st
Pass) through a bed of once used bleaching earth in one of the
Silica Pre-treatment eliminates Adsorbent Filters. The silica with adsorbed soap and gums is
need for water washing (in neutral- deposited on the filter bed. As the oil passes through the bed of
bleaching earth a large part of the color bodies in the oil
izing) and reduces earth consump-
(mainly chlorophyll) is removed by the still active bleaching
tion and oil losses by up to 20%. earth.
Bleaching: The pre-bleached and filtered oil is slurried with
DoublePass Filtration reduces bleaching earth before entering the Bleacher where the earth
earth consumption and oil losses by adsorbs the residual color bodies and other impurities. Residual
up to 30%. moisture and air are minimized as well by applying vacuum.
The oil is filtered again (2nd Pass) in a second Adsorbent Fil-
ters where the earth containing impurities and color bodies etc.
is retained. The fully bleached oil is collected in the filtrate
receiver and cooled before going to intermediate storage. Alter-
natively, the hot filtered oil can be sent directly to deodorizing.
Filter Operation: The system is equipped with three filters that
are cycled so that while one is being used to separate bleaching
earth another is separating silica as described above. In the
meantime the spent silica and earth collected in the 3rd filter is
dislodged and removed from the filter screens, and the cleaned
Crown Iron Works filter pre-coated and readied for a new cycle. The cycling of the
filters is automated and triggered by either high pressure or
P.O. Box 1364, Minneapolis, MN 55440 USA
Tel: +1-651-639-8900 Fax: +1-651-639-8051 elapsed time.
[email protected] www.crowniron.com
DoublePass Bleaching System

FEATURES AND ADVANTAGES

• Eliminates need for water wash step in “Long-Mix” neutralizing by


removing residual soap with silica adsorbent.
COLORS OF REFINING
• Reduces earth consumption up to 20% by separate filtration of
spent silica before adding bleaching earth.

• Reduces earth consumption by up to an additional 30% by pre-


bleaching incoming oil in a filter already filled with a packed bed
of still active bleaching earth.

• Separate slurry system for earth and oil allows for addition of wa-
ter and “wet” bleaching.

• Fully automated filtration cycles with minimal operator interaction.

• Optional vertical or horizontal tank filters.


Crude Neutralized Pre-Bleached Bleached Deodorized
• Optional mechanical or steam agitated bleacher.

• Optional system for addition of activated carbon.

• Plant sizes from 50 to 1,200 TPD (metric tons per 24 hours).


UTILITY CONSUMPTION

Typical figures per metric ton of oil heated to 90 oC by bleached


or deodorized oil in Feed Economizer:
IT’S A PIECE OF CAKE
Electric Power: 4 - 6 kWh depending on plant size
Steam (2 - 10 barg): 20 - 30 kg depending on type of oil
Cooling Water (30 oC): 2 m3 at UT 6 oC
Filter Aid: 0.8 kg
Silica: 0.5 - 1.0 kg depending on oil quality
Silica Process Water: 0 - 5 kg depending on type of earth
Bleaching Earth: 3 - 8 kg depending on type/quality of oil
Earth
Note: Cooling water is amount circulated per metric ton of oil.
Actual loss is typically 3% of this amount

Filter Aid
EQUIPMENT SPACE REQUIREMENTS

50 - 200 TPD: Two levels, each 110 m2 with 6 m elevation


200 - 600 TPD: Two levels, each 215 m2 with 8 m elevation
600 - 1200 TPD: Two levels, each 350 m2 with 8 m elevation
Note: Control room, MCC and adsorbent handling not included.

Crown Iron Works Europa Crown Ltd.


a CPM Company a CPM Company
P.O. Box 1364 Waterside Park. Livingstone Road
Minneapolis, MN 55440 USA Hessle, East Yorkshire, HU13 0EG England
Tel: +1-651-639-8900 Fax: +1-651-639-8051 Tel: +44-1482-640099 Fax: +44-1482-649194
[email protected] www.crowniron.com [email protected] www.europacrown.com

OFFICES: ARGENTINA, BRAZIL, CHINA, HONDURAS, INDIA, MEXICO, RUSSIA, UKRAINE


5/08

You might also like