0% found this document useful (0 votes)
268 views3 pages

Problem Set

The document outlines 7 practice problems related to allowable stress design for various structural elements. Problem 1 involves determining the maximum axial force on a thrust bearing before shear stresses exceed allowable values. Problem 2 involves sizing the thickness of a steel pipe supporting a load and ensuring safety factors against failure. Problem 3 involves determining the greatest load an oak post supported on a pine block can handle before exceeding allowable bearing stresses.

Uploaded by

Christian Rigon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
268 views3 pages

Problem Set

The document outlines 7 practice problems related to allowable stress design for various structural elements. Problem 1 involves determining the maximum axial force on a thrust bearing before shear stresses exceed allowable values. Problem 2 involves sizing the thickness of a steel pipe supporting a load and ensuring safety factors against failure. Problem 3 involves determining the greatest load an oak post supported on a pine block can handle before exceeding allowable bearing stresses.

Uploaded by

Christian Rigon
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

PROBLEM SET 2 (ALLOWABLE STRESS)

DEADLINE (MARCH 28,2023)


1. The thrust bearing consists of a circular collar A fixed to the shaft B. Determine the maximum
axial force P that can be applied to the shaft so that it does not cause the shear stress along a
cylindrical surface a or b to exceed an allowable shear stress of Ʈallow = 17MPa.

2. The steel pipe is supported on the circular base plate and concrete pedestal. If the normal
failure stress for the steel is σ fail st = 350 MPa, determine the minimum thickness t of the pipe
if it supports the force of 500 kN. Use a factor of safety against failure of 1.5. Also, find the
minimum radius r of the base plate so that the minimum factor of safety against failure of the
concrete due to bearing is 2.5. The failure bearing stress for concrete is (σfail) con = 25 MPa.

3. The oak post is supported on the pine block. If the allowable bearing stresses for these materials
are σoak= 43 MPa σpine = 25 MPa , determine the greatest load P that can be supported.
4. The frame is subjected to the load of 4 kN which acts on member ABD at D. Determine the
required diameter of the pins at D and C if the allowable shear stress for the material is Ʈallow =
40 MPa. Pin C is subjected to double shear, whereas pin D is subjected to single shear.

5. The two aluminum rods support the vertical force of P = 20 kN. Determine their required
diameters if the allowable tensile stress for the aluminum is σallow = 150 MPa.

6. If the allowable bearing stress for the material under the supports at A and B is σballow = 1.5
MPa. Determine the size of square bearing plates and required to support the load. Dimension
the plates to the nearest mm. The reactions at the supports are vertical. Take P = 100 kN.
7. To the nearest 1/16 in., determine the required thickness of member BC and the diameter of
the pins at A and B if the allowable normal stress for member BC is σallow = 29 ksi and the
allowable shear stress for the pins is Ʈallow = 10 ksi.

You might also like