Scribd
Upload
195 views

Tutorial 1-EEE

The document provides 7 tutorial questions covering topics such as designing a zener regulator circuit given specifications, calculating power and voltage gains in decibels, analyzing the output of a full wave bridge rectifier circuit, calculating the capacitor value needed for a bridge rectifier circuit to limit ripple, analyzing transistor circuits to determine current values, and calculating input power and voltage needed for cascaded and single amplifier circuits.

Uploaded by

Aer Z
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
195 views

Tutorial 1-EEE

The document provides 7 tutorial questions covering topics such as designing a zener regulator circuit given specifications, calculating power and voltage gains in decibels, analyzing the output of a full wave bridge rectifier circuit, calculating the capacitor value needed for a bridge rectifier circuit to limit ripple, analyzing transistor circuits to determine current values, and calculating input power and voltage needed for cascaded and single amplifier circuits.

Uploaded by

Aer Z
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

TUTORIAL-1

1. Design zener regulator for given specification.

Vin varies from 15V to 18V


RL varies from 225Ω to 2KΩ
VZ=9V
IZ(min)=10mA
Pd(max)=4.5W

2. The output power from an amplifier is 50mW when the signal frequency is 5KHz. The
output power falls to 25mw when the freq is 20 KHz. Calculate the power change in decibels.
3. An amplifier has a voltage gain of 100 at 1KHz. The gain falls by 6dB at 1MHz, if the
input is 3mW at 2MHz. calculate the output voltage.
4. A full wave bridge rectifier supplies a load of 2Kohm, the AC voltage applied is 200 V at
the secondary of transformer. If capacitor of 500 microF is connected across the load, find i)
Ripple factor ii) DC output voltage iii) DC load current iv) % of regulation.
5. A bridge rectifier has a supply 20 V to a 500 ohm load, the peak to peak ripple should not
exceed 10% of average output voltage and the AC input frequency is 60 Hz. Calculate the
capacitor value.
6. A silicon transistor has its Ico=6nA and α=0.98. If Ib=0 and Vce= 4V then
Ic=---------------
An NPN transistor has lco=30nA, Ib=0, Vce=4V and Ic=30uA .The value of β=-------------
7. a)Three amplifiers of voltage gain 20dB, 26dB and 32dB are cascaded to obtain an output
voltage of 2V. Calculate the input voltage needed.
b) An amplifier having a power gain of 17dB delivers a power output of 40W to a load of
1KΩ. Calculate i) the input power needed and ii) the input voltage needed, if the voltage gain
of the amplifier is 38dB.

You might also like