PV776 89200449

Download as pdf or txt
Download as pdf or txt
You are on page 1of 7

Service Bulletin

Mack Trucks, Inc.


Greensboro, NC USA Trucks
Date Group No. Release Page
This bulletin replaces bulletin 371–57 (PV776–89148563), “Data Link 4.2015 371 59 02 1(7)
Connection Overlay Harness, for Accessory Equipment, Installation” dated
11.2014.

Data Link Connection Overlay Harness, for


Accessory Equipment, Installation
CHU, CXU, GU, TD
Data Link Connection Overlay Harness, for
Accessory Equipment, Installation

PV776-89200449 USA70496
Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 2(7)

W3094896

W3094896

This harness can be used for adding components to the vehicles data links.

Required Parts
Item Description Part Number Qty
1 Jumper Harness 22427984 1
Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 3(7)

Service Procedures
3711-02-02-01
Data Link Connection Overlay Harness, for Accessory Equipment,
Installation
Note: Information is subject to change without notice.
Illustrations are used for reference only and can differ
slightly from the actual vehicle being serviced. However,
key components addressed in this information are repre-
sented as accurately as possible.

You must read and understand the precautions and guide-


lines in Service Information, group 30, "General Safety
Practices" before performing this procedure. If you are not
properly trained and certified in this procedure, ask your
supervisor for training before you perform it.

1
Secure the vehicle for service by parking it on a flat level sur-
face, applying the parking brake, chocking the rear wheels,
and placing the transmission in neutral.

2
Disconnect all cables from the negative (ground) battery ter-
minal to prevent personal injury from electrical shock and
prevent damage to electrical components.

3
Remove the Fuse and Relay Center (FRC) panel.

W3088470

1 Fasteners
2 FRC Panel
Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 4(7)

4
Remove the cable tie from the data link connection located
on the rear corner of the dash.

W3088471

1 Cable tie

5
Connect the data link from the cab harness to the overlay.

W3088472

1 Data Link Harness


Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 5(7)

6
Transfer the terminating resistor onto the overlay harness

W3088473

1 Terminating Resistor

7
Install ring terminals onto respective studs (1, 2, 5, 6, 7).

W3101014

8
Tighten ring terminal nuts.

9
Route the harness into position.
Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 6(7)

10
Secure harness with cable ties as required.

W3088477

1 Cable ties

11
Install all the previously removed cables to the negative
(ground) battery terminals.

12
Test the 9 pin adapter for proper function.

W3088478

1 Pin Adapter
Mack Trucks, Inc. Date Group No. Release Page
Service Bulletin 4.2015 371 59 02 7(7)

13
Install the FRC Panel and secure.

W3088470

1 Fasteners
2 FRC Panel

14
Remove the wheel chocks.

You might also like