Scribd
Upload
2K views4 pages

MCQ 2

A difference between calculating the sample mean and the population mean is 1 A) Only in the symbols, we use instead of u and n instead of n. B) we divide the sum of the observations by n - 1 instead of n. The observations are ranked and select the middle value for the c) population mean. D) There are no differences.

Uploaded by

Prakash Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
2K views4 pages

MCQ 2

A difference between calculating the sample mean and the population mean is 1 A) Only in the symbols, we use instead of u and n instead of n. B) we divide the sum of the observations by n - 1 instead of n. The observations are ranked and select the middle value for the c) population mean. D) There are no differences.

Uploaded by

Prakash Singh
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

A difference between calculating the sample mean and the population mean is

1
A) Only in the symbols, we use instead of and n instead of N. B) We divide the sum of the observations by n - 1 instead of n. The observations are ranked and select the middle value for the C) population mean. D) There are no differences.

2 Which of the following measures of central location is affected most by extreme values?
A) Median B) Mean C) Mode D) Geometric mean

3 Which level of measurement is required for the median?


A) Nominal B) Ordinal C) Interval D) Ratio

4 Which level of measurement is required for the mode?


A) Nominal B) Ordinal C) Interval D) Ratio

5 In a set of observations, which measure of central tendency reports the value that occurs
most often? A) Mean B) Median C) Mode D) Geometric mean

6 The weighted mean is a special case of the


A) Mean B) Median C) Mode

D) Geometric mean

7 The relationship between the geometric mean and the arithmetic mean is
A) They will always be the same. B) The geometric mean will always be larger. C) The geometric mean will be equal to or less than the mean. D) The mean will always be larger than the geometric mean.

8 Suppose you compare the mean of raw data and the mean of the same raw data
grouped into a frequency distribution. These two means will be A) Exactly equal. B) The same as the median. C) The same as the geometric mean. D) Approximately equal.

9 In a set of 10 observations the mean is 20 and the median is 15. There are 2 values that
are 6, and all other values are different. What is the mode? A) 15 B) 20 C) 6 D) None of the above.

10 Which of the measures of central tendency is the largest in a positively skewed


distribution? A) Mean B) Median C) Mode D) Cannot tell from the information given.

11 Which of the following is not a measure of dispersion?


A) Range B) Variance C) Standard deviation D) All of the above are measures of dispersion

12 A disadvantage of the range is


A) Only two values are used in its calculation. B) It is in different units than the mean.

C) It does not exist for some data sets. D) All of the above.

13 The mean deviation is


A) Based on squared deviations from the mean. B) Also called the variance. C) Based on absolute values. D) Always reported in squared units.

14 The standard deviation is


A) Based on squared deviations from the mean. B) In the same units as the mean. C) Uses all the observations in its calculation. D) All of the above.

15 The variance is
A) Found by dividing by N by the mean. B) In the same units as the original data. C) Found by squaring the standard deviation. D) All of the above.

16 In a positively skewed distribution


A) The mean, median, and mode are all equal. B) The mean is larger than the median. C) The median is larger than the mean.

D) The standard deviation must be larger than the mean or the median.

17 Which of the following statements is true regarding the standard deviation?


A) It cannot assume a negative value. B) If it is zero, then all the data values are the same. C) It is in the same units as the mean. D) All the above are all correct.

18 Under which of the following conditions would the standard deviation assume of negative
value. A) When all the data values were negative. B) When more than half of the data values were negative.

C) If all the data values were the same. D) The standard deviation cannot be negative.

19 The difference between a histogram and a bar chart is:


A) The midpoints are connected with a histogram but not with a bar chart. The bars must be next to each other on a histogram and separated in a B) bar chart. C) Cumulative frequencies are required in a bar chart. D) None of the above.

A,b b a c a c d c a d a c d c b d d b

You might also like