Scribd
Upload
47 views2 pages

Intervalos de Servicio

Uploaded by

Alejandro Valenzuela

410J John Deere

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt

Intervalos de Servicio

Uploaded by

Alejandro Valenzuela
47 views2 pages
410J John Deere

Original Title

Intervalos de servicio

Copyright

© © All Rights Reserved

Available Formats

PDF, TXT or read online from Scribd

Did you find this document useful?

Is this content inappropriate?

410J John Deere

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt
47 views2 pages

Intervalos de Servicio

Uploaded by

Alejandro Valenzuela
410J John Deere

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt
You are on page 1/ 2

Página 1 de 2

OMT219550 - 310SJ and 410J Backhoe Loader With Total Machine Control
(TMC)
Service Intervals

Service Intervals

-: Service Intervals

Model: 310SJ TMC and 410J TMC PIN/Serial Number:


Hour Meter Reading:

SERVICE INTERVALS
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement.
For example, at 500 hours also service those items listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.
FLUID SAMPLING
Take fluid samples from each system as indicated on this form. The manufacturer of the fluid analysis kits will provide
maintenance recommendations based upon the results of the fluid analysis and the operating information you supply.
Regular fluid sampling extends the operational life of your machine.

As Required
□ Inspect tires and check pressure □ Drain water and sediment from water separators
□ Check wheel fasteners □ Grease MFWD drive shaft spline (if equipped)
□ Clean or replace cab fresh air and recirculation filters (if □ Grease non-powered front wheel bearings (if equipped)
equipped)
 Clean or replace engine air cleaner elements □ Add coolant extender as indicated by COOL-GARD™ II
test strips

Every 10 Hours or Daily


□ Check hydraulic reservoir oil level □ Grease stabilizer pivots and cylinder pins
□ Check engine oil level □ Grease backhoe boom, crowd, swing and bucket cylinders
and pivots
□ Check coolant level □ Grease MFWD front axle and U-joints (if equipped)
□ Inspect fuel water sediment bowls □ Grease non-powered front axle steering pivots (if
equipped)
□ Grease loader pivot points □ Grease multipurpose bucket pivots (if equipped)
□ Grease loader quick coupler (if equipped) □ Grease backhoe coupler mechanical jack (if equipped)
□ Grease front axle pivot pin
Every 50 Hours
□ Check transmission oil level □ Grease backhoe coupler fittings (if equipped)

Initial Service - 250 Hours1


□ Change engine break-in oil and replace filter
1
Perform initial service once after the first 250 hours of operation.

Every 250 Hours


□ Check MFWD planetary housing oil level (if equipped) □ Check rear axle oil level

file:///C:/ProgramData/Service%20ADVISOR/Temp/OMT219550_09001faa81200159.ht... 24/01/2023
Página 2 de 2

□ Check MFWD front axle housing oil level (if equipped) □ Take engine oil sample
□ Check battery electrolyte level and tighten terminals

Every 500 Hours


□ Clean engine crankcase vent tube □ Take axle oil sample
□ Check air intake hose □Take diesel fuel sample
□ Check boom-to-dipperstick pin bolt torque □ Take engine coolant sample
□ Drain water and sediment from fuel tank □ Take transmission oil sample
□ Drain, warm and refill engine oil and replace engine oil filter □ Take hydraulic oil sample
□ Replace fuel filters

Every 1000 Hours


□ Check coolant □ Replace hydraulic reservoir breather
□ Clean, pack, and adjust non-powered front wheel bearings □ Replace fuel breather
(if equipped)
□ Replace transmission oil filter □ Drain and refill transmission oil
□ Replace hydraulic oil filter □ Replace engine air cleaner elements
□ Replace cab fresh air and recirculation filters (if equipped) □ Inspect belt

Every 2000 Hours


□ Drain and refill MFWD planetary housing oil (if equipped) □ Drain and refill rear axle and planetary oil
□ Drain and refill MFWD front axle housing oil (if equipped) □ Inspect and clean hydraulic reservoir fill screen
□ Adjust engine valve lash □ Drain and refill hydraulic reservoir oil

Every 6000 Hours


□ Drain and refill engine cooling system

COOL-GARD is a trademark of Deere & Company CS58540,000004F-19-20100519

file:///C:/ProgramData/Service%20ADVISOR/Temp/OMT219550_09001faa81200159.ht... 24/01/2023

You might also like