Scribd
Upload
238 views3 pages

Double Shear Test

The document describes a double shear test to determine the ultimate shear strength of a material. Key steps include: (1) placing a specimen in a double shear assembly and applying a compressive load until failure; (2) calculating the cross-sectional area and measuring the ultimate load at failure; and (3) using the load and area to calculate the ultimate shear stress. The test evaluates shear strength by applying opposing shear forces at two locations on the specimen.

Uploaded by

Bharanitharan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
238 views3 pages

Double Shear Test

The document describes a double shear test to determine the ultimate shear strength of a material. Key steps include: (1) placing a specimen in a double shear assembly and applying a compressive load until failure; (2) calculating the cross-sectional area and measuring the ultimate load at failure; and (3) using the load and area to calculate the ultimate shear stress. The test evaluates shear strength by applying opposing shear forces at two locations on the specimen.

Uploaded by

Bharanitharan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

DOUBLE SHEAR TEST

1. AIM:

To find the ultimate shear strength of the given material by conducting a


double shear test.

2. APPARATUS REQUIRED:
1. Compression Testing Machine.
2. Double Shear apparatus.
3. Vernier Caliper.

3. Theory:

3.1 Keywords:

Shear force: A force which is applied tangential forces which are

parallel but mutually acting in opposite'directions can be called shear


force. Any force which tends to shear off a material can be called
shear force.
Single shear: when a shear force acts at one place only, the force is
called single shear, example sharing of a rivet in a lap joint.
Double shear: when shear forces acts at two places, the forces is
called double shear, example shearing of a rivet in a double cover butt

Joint.

4. Lab test
procedure:
1. Measure the average diameter
of the given rod.
2. The specimen in the double shear assembly with proper side grips.
4.1 Observations:

Area of Ultimate load Ultimate


Shear
Material
Diameter cross
Sl.no in mm section Stress
Tonnes Newton
mm N/mm

4.2 Model Calculation: ristiet


Show the model calculation for cross sectional area and ultimate shear stress

of the given specimen.

4.3 Learn:

1. Assembly and arrangement in double shear bOx.

2. Principle of this test.

3. Examples where materials are subjected to single and double shear.


4. Practical use of this experiments.
3. Place the double shear assembly on the lower
platens of the compression testing
machine and lower the upper platen till the
assembly is tightly fixed between
platen.

4. Start the machine and apply the load on the double shear
assembly.
5. Note down the ultimate load at which the specimen fails.

6. Repeat the same procedure for number of specimens.


7. Calculate the ultimate shear stress using the formula given below for each
specimen and

take the average value of the ultimate shear stress.

Area of cross section of the specimen =


t di/4 mm

Ultimate shear stress


Ultimate load N/mm
2 x Area of crosS section

5. Result:

The Ultimate shear stress of the material of the given specimen is .

You might also like