0% found this document useful (0 votes)
261 views2 pages

Logarithmic Decrement

Logarithmic decrement is a measure of the rate of decay of amplitudes in an under-damped system. It is defined as the natural logarithm of the ratio of successive amplitude peaks on the same side of the mean position. The logarithmic decrement depends on the damping present - more damping results in a higher rate of decay and larger logarithmic decrement. It can be calculated using the ratio of amplitudes between cycles or from the periodic time and damping ratio of the system using mathematical formulas.

Uploaded by

nakul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
261 views2 pages

Logarithmic Decrement

Logarithmic decrement is a measure of the rate of decay of amplitudes in an under-damped system. It is defined as the natural logarithm of the ratio of successive amplitude peaks on the same side of the mean position. The logarithmic decrement depends on the damping present - more damping results in a higher rate of decay and larger logarithmic decrement. It can be calculated using the ratio of amplitudes between cycles or from the periodic time and damping ratio of the system using mathematical formulas.

Uploaded by

nakul
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Logarithmic Decrement (δ)

Fig.1 Displacement Versus Time Curve for Under Damped System


Logarithmic decrement: Logarithmic decrement is defined as the natural logarithm of the
ratio of successive amplitude on the same side of mean position.
The rate of decay in the amplitudes of under-damped system is measured by the parameter
known as logarithmic decrement.
Rate of decay in amplitudes depends on the amount of damping present in the system. So, if
the damping is more, then the rate of decay will also be more.
Let A and B are the two points on the successive cycles which shows maximum deflection as
shown in Fig 1.
The periodic time; 𝑡𝑝 = 𝑡2 − 𝑡1
2𝜋
𝑡𝑝 =
𝜔𝑑
2𝜋
𝑡𝑝 =
√(1 − 𝜉 2 )𝜔𝑛

The amplitude at time t1 and t2


𝑥1 = 𝑋𝑒 −𝜉 𝜔𝑛𝑡1 [sin(𝜔𝑑 𝑡1 + 𝜙)]

𝑥2 = 𝑋𝑒 −𝜉𝜔𝑛 𝑡2 [sin(𝜔𝑑 𝑡2 + 𝜙)]

𝑥2 = 𝑋𝑒 −𝜉 𝜔𝑛(𝑡1+𝑡𝑝 ) [sin (𝜔𝑑 𝑡1 + 𝜔𝑑 𝑡𝑝 + 𝜙)]

2𝜋
𝑥2 = 𝑋𝑒 −𝜉 𝜔𝑛(𝑡1+𝑡𝑝 ) [sin (𝜔𝑑 𝑡1 + 𝜔𝑑 + 𝜙)]
𝜔𝑑
𝑥2 = 𝑋𝑒 −𝜉 𝜔𝑛(𝑡1+𝑡𝑝 ) [sin(𝜔𝑑 𝑡1 + 2𝜋 + 𝜙)]

𝑥2 = 𝑋𝑒 −𝜉𝜔𝑛 (𝑡1 +𝑡𝑝 ) [sin(𝜔𝑑 𝑡1 + 𝜙)]


Now taking the ratio, we get;

𝑥1 𝑋𝑒−𝜉𝜔𝑛 𝑡1 [sin(𝜔𝑑 𝑡1 + 𝜙)]


=
𝑥2 𝑋𝑒−𝜉𝜔𝑛 (𝑡1 +𝑡𝑝 ) [sin(𝜔𝑑 𝑡1 + 𝜙)]
𝑥1
= 𝑒−𝜉𝜔𝑛(𝑡1 −𝑡1 −𝑡𝑝)
𝑥2
𝑥1
= 𝑒𝜉𝜔𝑛𝑡𝑝
𝑥2
Now the logarithmic decrement is given by;
𝑥1
𝛿 = log 𝑒 ( )
𝑥2
𝛿 = log 𝑒 (𝑒𝜉𝜔𝑛𝑡𝑝 )
𝛿 = 𝜉𝜔𝑛 𝑡𝑝
2𝜋
𝛿 = 𝜉 𝜔𝑛
√(1 − 𝜉2 )𝜔𝑛
2𝜋𝜉
𝛿=
√(1 − 𝜉2 )
The logarithmic decrement can also be determined as follows;
1 𝑥0
𝛿= log 𝑒 ( )
𝑛 𝑥𝑛
Where x0 = amplitude at the starting position, xn = amplitude after ‘n’ cycles

You might also like