Manual
Manual
Operating seps
1.-Please correctly insert the battery plug of the
bouncing car into the power socket of the car body,
and then load the battery compartment into the car
body, and close with the battery cover.
2.- Please place the bouncing car on the levelor
even ground.
3.- Switch on the power of the transmitter, when the
signal indicator on the transmitter and bouncing car
turns from the state of flashing into eternal bright
on, which represents the decoding has been
successfully finished and you can conduct operation
on each function.
4.- For detiled functional operation, please kindly
refer to the functional ilustration of the transmitter
and the operation of functional indication show non
page 2
Content
1.- USB wire x 1 PC
2.- Instruction manual x 1PC
3.- Bouncing Cushion x 2 Pcs
4.- Chargeable lithium battery x 1Pc
Battery Charging Instruction of the Bouncing Car
Please plug the usb charger into the usb pot of the
computer, and the connect the usb charging plug
with the wire end of the battery. when charging, the
red indicator of the usb will turn from eternal brigth
on into off, charging time is about 60 minutes.
When the batteries are fully chnaged, the red
indicator of the usb will turn from off into on, this
time the changing process is finished
only the usb incluided in this product can be used
for charging the bouncing car
Precauciones
1.- Asegúrese de que la batería tenga suficiente
energía antes de usar (el cable USB especial
incluido se debe usar para cargar)
2.- No permita que el producto se humedezca o
entre en contacto con agua.
3.-Retire las baterías dentro del carro que rebota o
apague el transmisor cuando no lo use
4.- En el caso de que el carro que rebota no pueda
estar rebotando cuando se ejecuta la función de
rebote, puede deberse a una potencia insuficiente.
Por favor, cargue las baterías del coche bourcing
5.- Cuando el transmisor ha sido decodificado con
éxito con la señal del carro que rebota, sin embargo,
el indicador rojo sigue parpadeando lentamente, esta
vez la energía de la batería dentro del transmisor
puede ser insuficiente y necesita reemplazar las
baterías del transmisor
6.- Por favor, manténgalo alejado del cuervo, objeto
giratorio de alta velocidad o en el suelo enrollado u
objeto trenzado.
Separaciones operativas
1.-Inserte correctamente el enchufe de la batería del
automóvil que rebota en la toma de corriente de la
carrocería del automóvil, luego cargue el
compartimiento de la batería en la carrocería del
automóvil y cierre con la tapa de la batería.
2.- Coloque el carro que rebota en el nivel o en el
suelo.
Contenido
1.- Cable USB x 1 ud.
2.- Manual de instrucciones x 1PC
3.- Cojín saltarín x 2 uds.
4.- Batería de litio recargable x 1Pc
Instrucciones de carga de la batería del coche que
rebota
Enchufe el cargador USB en la toma USB de la
computadora y conecte el enchufe de carga USB
con el extremo del cable de la batería. al cargar, el
indicador rojo del usb cambiará de brillo eterno a
apagado, el tiempo de carga es de aproximadamente
60 minutos. Cuando las baterías estén
completamente cambiadas, el indicador rojo del usb
cambiará de apagado a encendido, esta vez el
proceso de cambio ha terminado.
solo el usb incluido en este producto se puede usar
para cargar el auto que rebota
Bouncing
Forward/Backward
Acceleration
Dceleration