GENERAL CEILING NOTES CEILING LEGEND

1) REFER TO STRUCTURAL DWGS FOR MISCELLANEOUS

1 / A1.24B
METAL REINFORCEMENT AT CEILING MOUNTED
EQUIPMENT, AND COORDINATE WITH EQUIPMENT SUSPENDED GWB CEILING
MANUFACTURER. PROVIDE ADDITIONAL METAL SUPPORT (GWB)
COMPONENTS NOT INDICATED ON THE STRUCTURAL
DRAWINGS AS REQUIRED TO SUPPORT ALL ITEMS IN
ACCORDANCE WITH THE MANUFACTURER'S 2'-0" x 2'-0" ACOUSTICAL PANEL CEILING

SEE SHEET
RECOMMENDATIONS. (APC-1)

2) ALL LIGHTS, SPRINKLER HEADS, DIFFUSERS, FIRE ALARM

DEVICES AND OTHER COMPONENTS INSTALLED IN CEILINGS 2'-0" x 4'-0" ACOUSTICAL PANEL CEILING
TO BE CENTERED IN ACOUSTIC TILE UNLESS OTHERWISE (APC-2)
NOTED. LOCATION OF ALL COMPONENTS IN GWB CEILINGS
TO BE ALIGNED AND APPROVED IN WRITING BY ARCHITECT
PRIOR TO INSTALLATION, UNLESS NOTED, TYPICAL.
ACOUSTICAL PANELS
(APC-3)
3) MEASURE EACH CEILING AREA AND ESTABLISH LAYOUT
OF ACOUSTICAL TILES TO BALANCE BORDER WIDTHS AT
OPPOSITE CEILING EDGES UNLESS OTHERWISE NOTED.
AVOID USE OF LESS THAN HALF WIDTH TILES AT BORDERS GEOMETRIC ACOUSTICAL PANEL CEILING
AND COMPLY WITH RCP'S. NOTIFY ARCHITECT OF ANY (APC-4)
DISCREPANCIES PRIOR TO BEGINNING THE INSTALLATION.
A B C D E F G H
24'-0" 24'-0" 24'-0" 24'-0" 24'-0" 24'-0" 24'-0" 4) CONSTRUCTION MANAGER TO COORDINATE ALL ITEMS 2'-0" x 2-0" FRP ACOUSTICAL PANEL CEILING
(IE. (APC-5)
DUCTS, PIPING, ETC.) IN ORDER TO MAINTAIN LOCATION OF
ALL CEILING FIXTURES AND HEIGHTS AS INDICATED ON
ARCHITECTURAL DRAWINGS. ANY DEVIATION FROM
1'-8" 1'-8" ARCHITECTURAL DOCUMENTS MUST BE NOTED TO ACOUSTIC WOOD PANEL
PROFESSIONAL IN WRITING AND APPROVED PRIOR TO (WD-1)
CONSTRUCTION, NO EXCEPTIONS.

5) IN ELEC/MECH/EQUIPMENT ROOMS AND OTHERS WOOD BLADES

WITHOUT CEILINGS, PLACEMENT OF LIGHTS SHALL BE (WD-2)
COORDINATED WITH EQUIPMENT INSTALLED IN THE ROOM.
2'-0"

SEE MEP DRAWINGS FOR LIGHTING IN THESE AREAS.

SLOPED SLOPED ACOUSTIC WOOD PANEL,
GWB GWB 12 6) WHERE SINGLE LIGHTS ARE SHOWN IN SPACES, LIGHT IS W/ METAL TRAY INFILL
ACB

A4.01 TO BE CENTERED, UON. (WD-3)

CL

5'-0" TYPE A TYPE A

9
A3.12 7) WHERE DIMENSIONS FOR PLACEMENT OF LIGHTS ARE
ACOUSTIC WOOD PANEL
18'-0"

8'-0"

2'-0"

GRAD STUDENT NOT SHOWN, USE LIGHTS' RELATIONSHIP TO CEILING GRID

TO ESTABLISH PLACEMENT AS SHOWN. (WD-4)
OPEN OFFICE
4000 EXTERIOR
ACB

NELMS DIR OFFICE 8) CONSTRUCTION MANAGER TO PROVIDE LOCATION AND

ASST DIR OFFICE 10 PLASTER SOFFIT
CL

6" DIMENSIONS OF ALL COMPONENTS IN CEILING IN ACOUSTIC WOOD PANEL

10'-0" 4050C 4050B 12'-6 1/2" 10 10 COORDINATION DRAWINGS. SEE SPECIFICATIONS. (WD-5)
5'-0"

AB-1 CABANA BELOW

1'-0"
12'-5 1/4" 12'-5 1/4" 12'-10 1/2" 12'-10 1/2" 9) ALL DIMENSIONS AND INSTALLED SYSTEMS SHALL BE
GWB 10 GWB GWB GWB 1 CHECKED AND VERIFIED BY THE CONTRACTOR AT THE PIPE GRID
10'-0" 10'-0" 9'-4 7/8" SITE. (PIPE)

5'-0"
SEE 6 / A4.05
10'-0"

APC-1 APC-1 10'-0"

FOR TYPICAL 10) FOR RECESSED PROJECTION SCREENS (115213), SEE
CONF RM WD-3
11'-0"

AB-1 DETAILS EXPOSED NELMS POST-DOC TECHNOLOGY DRAWINGS.

AWP-3 4050A ACOUSTIC FELT BLADES
PAINTED VILLAGE 10'-0" (AB-1)
16'-0"

EQ EQ 11) LIGHT FIXTURES ARE INDICATED FOR LOCATION ONLY.

4050D APC-2

18'-0"
ACB

10'-0" 10'-0" 12) LIGHT FIXTURES IN STORAGE, MECHANICAL,

EQ EQ
CL

NELMS INSTITUTE ELECTRICAL, TELECOM, RESTROOMS AND OTHER AREAS ACOUSTIC FELT BLADES
WD-3 WD-3
HQ LOUNGE NOT REGULARLY OCCUPIED ARE OMITTED FROM (AB-2)
4050 4055 ARCHITECTURAL DRAWINGS. REFER TO ELECTRICAL
2'-0"

NELMS STAFF DRAWINGS FOR FIXTURE QUANTITIES AND TYPES.

4'-0"
ALIGN 4050E 10' - 0" HEIGHT ABOVE FIN FL LEVEL
(DASHED) LINE OF 11'-8" 11'-8"
OPENING BELOW 2 13) NOT ALL ACCESS DOORS ARE SHOWN, REFER TO XXX FINISH MATERIAL
GWB GWB MECHANICAL AND ELECTRICAL DRAWINGS FOR ADDITIONAL
10'-0" OFFICE ACCESS DOOR REQUIREMENTS.
10'-0"
APC-1
APC-1 4005 SIM 2'-0" 2'-0"

EQ
8 SIM SIM EXPOSED EXPOSED CEILING
10'-0" CIRCULATION 8 3 14) REFER TO SPECIFICATIONS FOR BASIS OF DESIGN FOR
7 A7.43 UNPAINTED PAINTED / UNPAINTED
OFFICE CL APC-2 C499A CEILING TYPES AND SUSPENSION SYSTEMS.
A4.01 3 A7.03 A4.06
4004

EQ
A4.03 15) REFER TO A7.50 FOR INFORMATION ABOUT ROLLER
SLOPED SLOPED SOFFIT, HEIGHT VARIES
SHADES.
SLOPED CL XXX FINISH MATERIAL
EQ EQ LIGHT, SED
GWB 10'-0" TYPE X TYPE "A" SEE: 1 / A7.43
2" 16) FOR DESIGNATION AWP-3 IN CEILING PLANS, PROVIDE
APC-1 BC05 TYPE "B" SEE: 4 / A7.43
2 TYPE B ACOUSTIC WALL PANELS AT ALL INTERIOR PARTITION
STAIR 3-4

30'-0"
A7.01 LIGHT, SED HEADER WALLS FROM 10' AFF TO UNDERSIDE OF CONCRETE DECK
10'-0" S498B ABOVE. REFER TO INTERIOR ELEVATIONS.
OFFICE AWP-3 ACOUSTIC WALL PANEL
APC-2 WEARABLES & EXPOSED 18" GLASS DRAFT
4003 IMPLANTS LAB PAINTED 12'-4" STOP, ALL SIDES 17) PLACING OF ACCESS DOORS IN HARD SURFACE
4001 APC-4 OF OPENING CEILINGS OR WALLS, UNLESS SHOWN ON THE
SLOPED 2 ARCHITECTURAL DRAWINGS, SHALL NOT BE ACCEPTED, RECESSED OR SURFACE
2
GWB 10'-0" A4.41 OPEN TO ABV UNLESS APPROVED IN WRITING BY THE ARCHITECT. MOUNTED DOWNLIGHT
APC-1 A7.42
TYPE B TYP. LOCATE AND INSTALL ALL WORK AS REQUIRED TO
SIM SIM SIM SIM EXPOSED 3 PRECLUDE THE NEED FOR ACCESS THROUGH HARD
1 6 5 4 5 5 LAY-IN FIXTURE
OFFICE PAINTED A7.03 SURFACE WALLS AND CEILINGS. COORDINATION OF THIS
A7.01 A7.03 A7.03 A4.05 A7.03 A7.03 REQUIREMENT SHALL BE THE RESPONSIBILITY OF THE
4002 ROLL DOWN CONSTRUCTION MANAGER.
SMOKE CURTAINS, SUSPENDED FIXTURE
TYP. OF 4 BAYS 3 18) AT STAIR 1 AND STAIR 2, STEEL PAN STAIR SYSTEM TO
BE FACTORY PRIMED AND FIELD PAINTED.
5 SUSPENDED LINEAR FIXTURE
SIM 8
A4.05 7 12 5 8 1 4 19) FOR CEILING PAINTING DETAILS, REFER TO

10'-0"
9'-6" 9'-6" A4.02 CIRCULATION
1 A4.03 A4.03 A4.00 A4.04 A4.03 SPECIFICATIONS, AND SCHEDULE ON SHEET A9.21.
MOTORIZED WD-2 WD-2 C499D RECESSED LINEAR FIXTURE
A7.00
ROLLER SHADES
SEE: 1 / A7.50.
4 SUSPENDED SMALL ROUND FIXTURE
WC
4012
CIRCULATION 10'-0"

FS
GWB SUSPENDED LARGE ROUND FIXTURE
STAIR 1 ELEV 2 C499C 9'-0" SHAFT WORK ROOM
S498A E497B LOUNGE
CONF RM APC-5 SH-2 4015
9'-8"
4006 4010 WD-1
ELEC
10'-0" SPRINKLER HEAD
EL495A 9'-8"
CIRCULATION

17'-0"
ELEV 1 WD-1 GWB
EXPOSED E497C 10'-0" 9'-8" 10'-0" EXPOSED C499E

FS
ELEV 3 9'-8" GWB WD-1 GWB NURSING
PAINTED 10'-0" UNPAINTED S CEILING MOUNTED SENSOR
E497A GWB WD-1 4011 9'-8"
WD-1
9'-0"
APC-1 SP CEILING MOUNTED SPEAKER
FS 5
2'-0" 2'-5"

CL CL CL
SLOPED OFFICE STOR
10'-0"
ALIGN

4101 EQ EQ EQ EQ PROJECTOR
GWB 4102 APC-1
TYPE B CL
FS CEILING MOUNTED FIRE ALARM DEVICE
CYBER PHYSICAL
10'-0" ELECTRONICS STRUCTURAL
SYSTEMS EQ EQ EQ EQ SMART SYSTEMS
APC-1 TEST & HEALTH
RESILIENCE & LAB MOTORIZED ROLLER SHADE
SLOPED MEASUREMENT MONITORING LAB
ENERGY
LAB 4120 SEE: 20 / A7.50
GWB
EQ CL EQ MANAGEMENT LAB 4114 10'-0"
TYPE B
4100 10'-0" 10'-0"
4109 10'-0" APC-2
GWB APC-2 APC-2

33'-0"
8
A4.01 OFFICE 10'-0"
4103 APC-1
EQ

SLOPED 4'-0" ALIGN 4'-0" ALIGN SIM

GWB 10'-0" CL 10'-0" 2 CIRCULATION 5 10'-0" 3
5
APC-2 APC-2 C499C A4.42A APC-2 A7.42
A4.41 A4.42A
EQ

TYPE B
SM CONF RM
4104 OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE OFFICE
10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" 10'-0" OFFICE 10'-0" 10'-0"
10'-0"
APC-2 4105 APC-1 APC-1 4106 4107 APC-1 APC-1 4108 4110 APC-1 APC-1 4111 4112 APC-1 APC-1 4113 4115 APC-1 APC-1 4116 4117 APC-1 APC-1 4118 4119 APC-1 4123 APC-1
16
A4.02
6

FS
3 2
SLOPED A4.01 SLOPED SLOPED SLOPED SLOPED SLOPED SLOPED
A4.01
GWB GWB GWB GWB GWB GWB GWB
TYPE A TYPE A TYPE A TYPE A TYPE A TYPE A TYPE A
MOTORIZED
ROLLER SHADES
11 SEE: 7 / A7.50.

1 / A1.24B

1 RCP WEST - LEVEL 4

SEE SHEET

A1.24A SCALE: 1/8" = 1'-0"

Seal No. Description Date

Architect Associated Architect Structural Engineer MEPFP Engineer
Bohlin Cywinski Jackson Walker Architects Walter P. Moore Affiliated Engineers (AEI)
8
10
ASI-004
ASI-006
10.29.21
01.21.22 REFLECTED CEILING PLAN Date
20 AUGUST 2021
Scale
As indicated
1100 Ludlow Street, Suite 600 2035 NW 13th Street 201 East Kennedy Blvd., Ste 300 12921 SW 1st Rd, Suite 205 11 ASI-007 03.04.22
Philadelphia, PA 19107 Gainesville, FL 32609 Tampa, FL 33602 Newberry, FL 32669 WEST - LEVEL 4
19301
Acoustical Consultant Code Consultant Civil Engineer Landscape Architect THE MALACHOWSKY DATA BCJ Project Number
A1.24A
3/4/2022 4:46:46 PM

Siebein Associates, Inc

625 NW 60th St., Suite C
Holmes Keogh Associates LLC
526 East 20th Street, Apt 4D
CHW
11801 Research Drive
CHW
11801 Research Drive
SCIENCE & INFORMATION CONFORMED BID SET UF-632
Gainesville, FL 32607 New York, NY 10009 Alachua, FL 32615 Alachua, FL 32615 TECHNOLOGY BUILDING UF Project Number Sheet Number