Clariant Formulation Baby No Tears Shampoo and Conditioner 201501 en
Clariant Formulation Baby No Tears Shampoo and Conditioner 201501 en
Clariant Formulation Baby No Tears Shampoo and Conditioner 201501 en
Procedure
I Mix Phase A and heat up to 45°C until dissolved.
II Mix Phase B and heat up to 70°C until dissolved.
III Add C into II and add I into II.
IV Add D into III.
V Add Glycerin into IV.
V Add Genapol® LT in VI
VI Mix I to VII
VIII Adjust the pH with Citric Acid or Sodium Hydroxide to 5.30-5.50.
Results Appearance:
pH:5,30 - 5,50 Slightly yellow, blurry-to-clear liquid
Viscosity (Brookfield, 25°C1 2 rpm, sp 3): Stability:
4000 – 8000 mPas Results according to 3M, NC to 45oC Stability testing
*Recommended Preservation was checked by a Challenge-Test according to European Pharmacopoeia.
Challenge Test Results with Various Preservative Percentages:
1,20 % Nipaguard SCE: Pass A
1,40 % Nipaguard SCE: Pass A
0,50 % Nipaguard POB: Pass A
0,80 % Nipaguard POB: Pass A
1,00 % Nipaguard POB: Pass A
This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not
therefore be construed as guaranteeing specific properties of the product described or their suitability for a particular application. Any existing industrial
property rights must be observed. The quality of our products is guaranteed under our General Conditions of Sale.
This information is based on our present state of knowledge and is intended to provide general notes on our products and their uses. It should not
therefore be construed as guaranteeing specific properties of the product described or their suitability for a particular application. Any existing industrial
property rights must be observed. The quality of our products is guaranteed under our General Conditions of Sale.