Wireless Door Lock Control System Registration Procedure
Wireless Door Lock Control System Registration Procedure
REGISTRATION PROCEDURE
HOW TO CODE REGISTRATION
NOTICE:
When replacing the theft deterrent ECU or transmitter, registration of recognition code is necessary
because they are provided as a single components.
(a) Select the operation mode to perform from the following operation modes.
S Add mode
S Rewrite mode
S Prohibition mode
S Confirmation mode
HINT:
S The ”Add mode” is for adding the newly recognized codes for registration while the already registered
codes are retained. This mode is used when the transmitter is added. When the number of the regis-
tered codes exceeds 4 codes, the previously registered codes will be erased in order, staring from the
first registered code.
S The ”Rewrite mode” is for erasing all the registered codes and registering newly recognized codes only.
This mode is used when the transmitter or the door control receiver is replaced.
S The ”Prohibition mode” is for erasing all the registered codes to prohibit the wireless door lock opera-
tion. This mode is used when the transmitter is lost.
S The ”Confirmation mode” is for confirming the number of recognition codes that are registered. This
mode is used to check the number of registered codes when new codes are added to the registration,
etc.
(b) Follow the chart on the following page to register the transmitter recognition code to the theft deterrent
ECU.
HINT:
S When procedure is out of the specified, the registration operation is cancelled.
S Maximum 4 recognition codes can be registered.
START
Transmitter SW Operation:
HINT: Perform this operation during the countdown screen.
Press both lock and unlock SW. (Between 1 and 1.5 sec.)
Within 3 sec.
Press any one of SW. (For more than 1 sec.)
END
HINT:
This page is to show briefly the registration procedure using the hand−held tester.
For detailed procedures, please refer to the prompts on the tester screen.
The number of currently registered codes can be checked out on the first screen of the WIRELESS REG-
ISTRATION.
2003 LEXUS LS430 (RM988U)
Within 5 sec. Insert and remove the key into/from the ignition cylinder twice.
Insert→remove →insert→remove
Insert and remove the key into/from the ignition cylinder once.
Insert→remove
Within 40 sec.
HINT: If the IG switch operation is
not performed with the specified
number of times (If it is 4 times, 6
times or more), this operation is
finished with no response.
Mode Selection
Press both lock and unlock SW. (Between 1 and 1.5 sec.)
Within 3 sec.
Press any one of SW. (For more than 1 sec.)
Continue
the registration.
Register other transmitters?
Within 40 sec. or
Finish the registration?
Perform one of the following operations to finish the Add mode and the
Rewrite mode.
D Insert the key into the IG key cylinder.
D Open any one of the doors.
D Wait for 40 sec. after the code registration.
HINT: In case of registering 4 codes at a time, the mode will be finished
when the 4th code is registered.
HINT:
Operation cycle of the door lock (lock/unlock operation)
LOCK
*1: Door Lock Motor
UNLOCK
1 Sec. 1 Sec.
LOCK
*2: Door Lock Motor
UNLOCK
2 Sec. 2 Sec.