SBNHH-1D45C Product Specifications

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

SBNHH-1D45C

6-port sector antenna, 2x 698–896 and 4x 1695–2360 MHz, 45°


HPBW, 3x RET

Interleaved dipole technology providing for attractive, low wind load mechanical package
Three internal RETs for independent tilt on all three bands

General Specifications
Antenna Type Sector

Band Multiband

Color Light gray

Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket

Performance Note Outdoor usage    |   Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN

Radome Material Fiberglass, UV resistant

Radiator Material Aluminum    |   Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 7-16 DIN Female

RF Connector Location Bottom

RF Connector Quantity, high band 4

RF Connector Quantity, low band 2

RF Connector Quantity, total 6

Remote Electrical Tilt (RET) Information


RET Interface 8-pin DIN Female    |   8-pin DIN Male

RET Interface, quantity 1 female    |   1 male

Input Voltage 10–30 Vdc

Internal RET High band (2)    |   Low band (1)

Power Consumption, idle state, maximum 2W

Power Consumption, normal conditions, maximum 13 W

Protocol 3GPP/AISG 2.0 (Multi-RET)

Page 1 of 4

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
SBNHH-1D45C
Dimensions
Width 457 mm   |   17.992 in

Depth 178 mm   |   7.008 in

Length 2437 mm   |   95.945 in

Net Weight, without mounting kit 36.1 kg   |   79.587 lb

Array Layout

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2360 MHz    |   698 – 896 MHz

Polarization ±45°

Electrical Specifications
Frequency Band, MHz 698–806 806–896 1695–1880 1850–1990 1920–2200 2300–2360
Gain, dBi 18.3 18.6 19.6 20.2 20.5 21
Beamwidth, Horizontal, 47 43 44 42.6 42 39
degrees
Beamwidth, Vertical, degrees 8.9 8.2 5.8 5.3 5.1 4.5
Beam Tilt, degrees 0–10 0–10 0–8 0–8 0–8 0–8
USLS (First Lobe), dB 17 16 20 20 19 16
Front-to-Back Ratio at 180°, 30 31 33 35 35 36

Page 2 of 4

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
SBNHH-1D45C
dB
CPR at Boresight, dB 25 19 20 24 17 17
CPR at 10 dB Horizontal 11 16 10 10 10 10
Beamwidth, dB
Isolation, Cross Polarization, 25 25 25 25 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -153 -153 -153 -153 -153 -153
Input Power per Port, 350 350 350 350 350 300
maximum, watts

Electrical Specifications, BASTA


Frequency Band, MHz 698–806 806–896 1695–1880 1850–1990 1920–2200 2300–2360
Gain by all Beam Tilts, 17.9 18.5 19.2 20 20.3 20.8
average, dBi
Gain by all Beam Tilts ±0.5 ±0.2 ±0.5 ±0.4 ±0.4 ±0.4
Tolerance, dB
Gain by Beam Tilt, average, 0 ° | 17.8 0 ° | 18.4 0 ° | 19.2 0 ° | 20.0 0 ° | 20.2 0 ° | 20.8
dBi 5 ° | 18.0 5 ° | 18.6 4 ° | 19.3 4 ° | 20.0 4 ° | 20.3 4 ° | 20.9
10 ° | 17.9 10 ° | 18.4 8 ° | 19.0 8 ° | 19.8 8 ° | 20.1 8 ° | 20.5

Beamwidth, Horizontal ±1.6 ±2.3 ±1.8 ±0.9 ±1 ±1.6


Tolerance, degrees
Beamwidth, Vertical ±0.5 ±0.3 ±0.3 ±0.2 ±0.3 ±0.1
Tolerance, degrees
USLS, beampeak to 20° above 16 16 16 16 17 16
beampeak, dB
Front-to-Back Total Power at 24 25 29 31 32 33
180° ± 30°, dB
CPR at Boresight, dB 25 22 22 26 21 19
CPR at 10 dB Horizontal 14 18 13 11 11 12
Beamwidth, dB

Mechanical Specifications
Effective Projective Area (EPA), frontal 1.4 m²   |   15.069 ft²

Effective Projective Area (EPA), lateral 0.3 m²   |   3.229 ft²

Wind Loading @ Velocity, frontal 1,485.0 N @ 150 km/h (333.8 lbf @ 150 km/h)

Wind Loading @ Velocity, lateral 315.0 N @ 150 km/h (70.8 lbf @ 150 km/h)

Wind Loading @ Velocity, maximum 1,485.0 N @ 150 km/h (333.8 lbf @ 150 km/h)

Wind Loading @ Velocity, rear 1,304.0 N @ 150 km/h (293.2 lbf @ 150 km/h)
Page 3 of 4

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021
SBNHH-1D45C
Wind Speed, maximum 241 km/h   |   149.75 mph

Packaging and Weights


Width, packed 567 mm   |   22.323 in

Depth, packed 311 mm   |   12.244 in

Length, packed 2559 mm   |   100.748 in

Weight, gross 55.8 kg   |   123.018 lb

Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Included Products
BSAMNT-3 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.
BSAMNT-M – Middle Downtilt Mounting Kit for Long Antennas for 2.4 - 4.5 in (60 - 115 mm) OD round
members. Kit contains one scissor bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 4

©2021 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 14, 2021

You might also like