Hardware Revision List: Nokia Siemens Networks Flexi Network Gateway Release 10
Hardware Revision List: Nokia Siemens Networks Flexi Network Gateway Release 10
Hardware Revision List: Nokia Siemens Networks Flexi Network Gateway Release 10
Gateway Release 10
DN0962773
Issue 2-0
The information in this document is subject to change without notice and describes only the
product defined in the introduction of this documentation. This documentation is intended for
the use of Nokia Siemens Networks customers only for the purposes of the agreement under
which the document is submitted, and no part of it may be used, reproduced, modified or
transmitted in any form or means without the prior written permission of Nokia Siemens
Networks. The documentation has been prepared to be used by professional and properly
trained personnel, and the customer assumes full responsibility when using it. Nokia Siemens
Networks welcomes customer comments as part of the process of continuous development
and improvement of the documentation.
The information or statements given in this documentation concerning the suitability, capacity,
or performance of the mentioned hardware or software products are given “as is” and all
liability arising in connection with such hardware or software products shall be defined
conclusively and finally in a separate agreement between Nokia Siemens Networks and the
customer. However, Nokia Siemens Networks has made all reasonable efforts to ensure that
the instructions contained in the document are adequate and free of material errors and
omissions. Nokia Siemens Networks will, if deemed necessary by Nokia Siemens Networks,
explain issues which may not be covered by the document.
Nokia Siemens Networks will correct errors in this documentation as soon as possible. IN NO
EVENT WILL NOKIA SIEMENS NETWORKS BE LIABLE FOR ERRORS IN THIS
DOCUMENTATION OR FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO
SPECIAL, DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL OR ANY LOSSES,
SUCH AS BUT NOT LIMITED TO LOSS OF PROFIT, REVENUE, BUSINESS
INTERRUPTION, BUSINESS OPPORTUNITY OR DATA,THAT MAY ARISE FROM THE
USE OF THIS DOCUMENT OR THE INFORMATION IN IT.
This documentation and the product it describes are considered protected by copyrights and
other intellectual property rights according to the applicable laws.
The wave logo is a trademark of Nokia Siemens Networks Oy. Nokia is a registered trademark
of Nokia Corporation. Siemens is a registered trademark of Siemens AG.
Other product names mentioned in this document may be trademarks of their respective
owners, and they are mentioned for identification purposes only.
Copyright © Nokia Siemens Networks 2010. All rights reserved.
Contents
2 Mechanics ...............................................................................................7
3 Electromechanics...................................................................................8
4 Shelf parts...............................................................................................9
5 Blades ...................................................................................................10
7 Cables ...................................................................................................12
Glossary ……………………………………………………………………................. 13
Summary of changes
Issue 2-0
Revision lists updated for Flexi NG CD4.
Issue 1-0
This is the first issue of this document.
This document lists the hardware product revisions that are supported in
each Flexi NG main product release, and between the main product releases.
You should refer to the revision lists, for example, to verify before
commissioning or upgrading; or when you are replacing the hardware that
the network element complies with the requirements of a new software
release. This way, you can make sure that you will not be equipping
hardware ─ or combinations of hardware ─ that might harm the system or its
services.
*Note:
Interchangeability indicates a
difference in functionality for
a given product.
Interchangeablity A indicates
the first approved product
which is upgradeable to the
next level (interchangeablity
B) and so on.
Usually only one
interchangeability level is
allowed for one HW product,
but if two or more different
levels are given in this
document, they can all be
used. The latest
interchangeablity is always
allowed.
Revision lists do not include
version number, since the
version has no effect on
interchangeability. In other
words, all available versions
of a product are allowed as
long as interchangeability is
supported.
2 Mechanics
AMCSF-A A C110658 X
AMCSF-A B C110658 X
ASFF6-A A C110657 X X
ASFR6-A A C110659 X X
D208-A B C110583 X X
EC208-A B C110582 X X
MA195-A A C112348 X
MA196-A A C112148 X
SHAFE10 A C111465 X X
3 Electromechanics
ADPDU-A B C111008 X X
4 Shelf parts
ACH16-A A C110656 X X
ADPEM-A A C110576 X X
AFAMO-A A C110638 X X
AFAMO-A B C110638 X X
ASMGR-A A C110581 X X
CHAF2-A A C110639 X X
SHALD-A A C110997 X X
SHALP-A A C110998 X X
SHCDM-A A C111000 X X
5 Blades
6 Plug-in modules
7 Cables
CGNDA A X X
CGNDB A X X
CVKPL A X X
CVKPR A X X
Glossary