EN TEMP OCT I Cruise control for skoda octavia i

WARNING: Carefully read following instructions and technical specifications III. SCHEMATIC FOR CRUISE CONTROL
in this manual before installation. The system must be installed and used only accord-
ing to this manual. The system is designed for vehicles with 12V power supply and
CAN BUS. It has to be connected to 12V output and to the ground. Neither producer
or seller of the system is responsible for damages caused by incorrect installation,
using or operating of this product. Unprofessional operation or modification of the
system can damage the system alone, or the electric system of the vehicle and leads
to warranty loss. For proper working of the system we recommend the installation
to be made by authorized service.

System description
TEMP OCT I is original cruise control that is designed for installation in vehicles
Skoda Octavia I. The vehicle must be equipped with electronic throttle control.

Set contains:
• 1x switching lever under steering wheel SKODA OCTAVIA • 1x auxiliary
block 1pole

Set does not include cruise control harness!

I. SYSTEM INSTALLATION
- disconnect vehicle battery
- dismantle switch under steering wheel
- dismantle panel under dashboard
- dismantle the lower part of the dashboard
- release fuse box
- divide the switch under the steering wheel into two parts and the replace the left
side with cruise control switch
- insert set back to the control rod -detail-
- remove the cap (4) of mount terminal in the separating space, disconnect black
10pole terminal (5) - arrow- , the terminal holder in separating space is located
in the engine compartment underneath the wiper actuator
- punch counterpart of 10pole terminal block (5) into the inner space of the
vehicle
- remove the black/blue wire from fuse box (position 5) and insert it into atta-
ched 1pole terminal (3)
- slide sleeve of red/white wire of cruise control (2) to the free position (position
5)
- connect the attached 1pole terminal to the 1pole terminal of cruise control
harness
- black 10pole terminal connect to the appropriate terminal located under the
steering wheel (1)
- four free wires (blades) connect to the 10pole terminal counterpart located in
the inner space of vehicle following this:
- blue wire PIN 1
- red/yellow wire PIN 2
- black/white wire PIN 3
- red/gray wire PIN 9
- put on 10pole terminal counterpart back to the terminal holder in separating
space (pic. 7)
- fasten cruise control harness (2) with clips above the ignition switch box to the
existing electrical installations of switch box
- connect all disconnected terminals
- reattach all removed parts and connect the battery

II. CRUISE CONTROL ACTIVATION

Check the proper functionof cruise control by test drive!