B50HES1111-08

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Name : B50HES1111-08 Rev : - Release : 2020/03/10 11:48 AM

PRODUCT PROCUREMENT SPECIFICATION B50HES1111-08



Plates EN 10025-2 –
S355 J0+N / S355 J2+N Rev. - Page: 1 / 2

RESTRICTIVE CONTRACT REQUIREMENTS INDICATED IN PURCHASE ORDER (PO) PREVAIL ONTO THIS SPECIFICATION

Chemical Composition
Chemical composition of the Heat analysis is according to EN 10025-2.

Maximum CEV (Carbon Equivalent as per IIW formula) of the Heat analysis is according to EN 10025-2 and with the
restrictive value:
Thickness range CEV
30 < Th. ≤ 250 mm 0,45

Delivery Conditions
The plates shall be supplied in the normalized (+N) condition as defined in EN 10025-2.

Mechanical Characteristics
Mechanical characteristics are according to EN 10025-2.

Charpy V-Notch Impact tests shall be tested as per material designation indicated in the Bill of Material.
Note: Tests at -20°C (J2) fulfill the requirement of tests at 0°C (J0), but not the contrary.

Tolerances on dimensions and shape


Tolerances on dimensions and shape of the plates are according to EN 10029 and criteria:

▪ Class B for plate thickness tolerances

▪ Class N for flatness tolerances

Delivery requirements for surface conditions


Surface requirements and repair conditions are according to EN 10163-2 and criteria:

▪ Class B Sub-class 3

Ultrasonic testing
Ultrasonic testing method is according to EN 10160 and criteria:

▪ S1E2

Date Written by Checked by Approved by

January 2020 Ph Feriol G Bougaran T Kunz


© Copyright 2020 – GE Renewable Energy. All rights reserved. Reproduction of any nature by any means, modifications, use or disclosures to third parties without
express authority is strictly forbidden. GE Confidential
Name : B50HES1111-08 Rev : - Release : 2020/03/10 11:48 AM
PRODUCT PROCUREMENT SPECIFICATION B50HES1111-08

Plates EN 10025-2 –
S355 J0+N / S355 J2+N Rev. - Page: 2 / 2

Marking
Each plate must be identified according to EN 10025-1.

The legibly marked must not affect the metallurgical and mechanical properties of the plates.

The following information shall be written as a minimum:

▪ Steel grade designation as per GE Bill of Material and PPS number

▪ Heat number,

▪ Manufacturer’s name or trademark according to production plan,

▪ The mark of the external inspector representative (where applicable),

▪ Plate number,

▪ Rolling direction.

▪ Dimensions of the plates (size and thickness)

Delivery certificate
Types of inspection documents per plate are according to EN 10204 and criterion:

▪ 3.1

Product delivery certificate shall report all tests and information required by this specification, the associated
applicable product standard and any additional requirements of the P.O.

© Copyright 2020 – GE Renewable Energy. All rights reserved. Reproduction of any nature by any means, modifications, use or disclosures to third parties without
express authority is strictly forbidden. GE Confidential

You might also like