The document contains G-code instructions for engraving a design onto a material that is 250mm x 200mm x 3mm in size. It uses a single engraving tool at an angle of 30 degrees with a tip size of 0.02-3mm to engrave the design. The G-code instructions provide coordinate positions and feed rates to direct the tool along the toolpath called "1poke" which contains numerous line segments to engraving the design.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
0 ratings0% found this document useful (0 votes)
21 views25 pages
1 Poke
The document contains G-code instructions for engraving a design onto a material that is 250mm x 200mm x 3mm in size. It uses a single engraving tool at an angle of 30 degrees with a tip size of 0.02-3mm to engrave the design. The G-code instructions provide coordinate positions and feed rates to direct the tool along the toolpath called "1poke" which contains numerous line segments to engraving the design.