Power System Stability Improvement Using Statcom

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 2

Power System Stability Improvement Using

STATCOM

This present the model of STATCOM which controllers the


rotor angle deviation, voltage stability, transient stability for
the improvement of power system stability. The development
of the Morden power system has led to increase the complexity
in the study of power system and also present new challenges
to power system. The stability plays an important role to
ensure the stable operation of power system in the occurrence
of large disturbances and faults. The role of STATCOM will be
mitigate the voltage problem like voltage sag, voltage swell
which are generally occurs in power system during high
voltage and low voltage condition. A power system network is
considered which is simulated in phase simulation method and
the network is simulated in 3 steps i.e. with and without
STATCOM and with PSS. When the load increases suddenly
the system has been disturbed so for greater performance
STATCOM will be used

CONTROL CONCEPT OF STATCOM


STATCOM is the shunt connected solid state switching computer capable of
generating or absorbing independently controllable real and reactive power of its
output terminal. When it is fed form energy source or storage device at its input
terminal the simplified diagram and equivalent model of STATCOM connected to
the power system. Which this STATCOM is modelled Xs the STATCOM is a shunt
compensation component which injects leading or lagging current into the ac system
.it is originally designed for voltage maintained in power system by reactive power
short circuit. It is based on a prerogative electronics voltage-source converter and be
capable of show as both a track down and sink of imprudent AC dominance to an
electricity network. If linked to a fund of sway it be able to moreover bestow on the
go AC power. Mostly a STATCOM is installed to endorse electricity networks that
partake of a bad muscle cause and habitually bad voltage regulation. A STATCOM
is a voltage cause converter (VSC)-based device, with the voltage spokesperson
behind a reactor. The voltage track down is produced from a DC capacitor and
consequently a STATCOM has enormously modest full of zip state capability.
However, it’s in force strength capability preserve be bigger if an apt energy cargo
space emblem is tied across the DC capacitorr. The reactive power at the terminals of
the STATCOM depends on the amplitude of the voltage source [5]A STATCOM is
an electrical device for providing fast acting reactive power compensation on high
voltage transmission network and it can
be contribute to improve the voltage and power stability after fault in these study a
phasor STATCOM without controller and STATCOM with controller is simulated
with a view to get better performance, a new PSS has been designed and proposed
for STATCOM to inject voltage externally for the improvement of power system
stability thyristor based STATCOM with PSS controller has been used to
improvement the performance of power system is discussed[1] [10] in PSS controller
is used then any rating of STATCOM is enough for stabilization of different type of
condition

You might also like