Republic of the Philippines

Department of Education
REGION III
DIVISION OF PAMPANGA
SAN JOSE HIGH SCHOOL
SAN JOSE, FLORIDABLANCA, PAMPANGA

FINAL EXAM IN PHYSICS II

NAME: ______________________ GR. & Sec: ___________ Date: _______ Score: ______

Direction: Write the letter on your answer sheet.

1. Three capacitor of capacitance 3microfarad are connected in a circuit. That their maximum and minimum
capacitance wil be.
A. 3microfarad,2microfarad C. 8micrfarad,2microfarad
B. 9microfarad, 1microfarad D. 9micrfarad,0microfarad
2. When two identical capacitors are in series have 3 microfarad capacitance and when parallel 12microfarad. What
is the capacitance of each?
A.3microfarad B.6microfarad C.9microfarad D.12microfarad
3.Three capacitor of 2microfarad,3microfarad,and 6microfarad are joined in series and the combination charged by
means of a 24 volt battery. The potential difference between the plates of 6microfarad is
A.4volt B.6volt C.8volt D.10volt
4.Two capacitors of capacitances 3microfarad and 6 microfarad are charged to a potential of 12V each. They are now
connected to each other, with the positive plate of each joined to the negative plate of the other. The potential
difference across each will be
A.Zero B.3Volt C.4Volt D.6Volt
5.Three capacitors each of capacity 4microfarad are to be connected in such a way that the effective capacitance is
6microfarad. This can be done by
A.Connecting them in parallel C.Connecting two in parallel and one in series
B.Connecting two in series and one in parallel D.Connecting all of them in series
6.Two equal negative charge –q are fixedpoints (0,a) and (0, -a) on the Y-axis. A positive charge Q is released from rest
at the points (2a,0) on the X-axis. The charge Q will
A.Execute simple harmonic motion about the origin C.Move to infinity motion
B.Move to the origin and remain at rest D.Execute oscillatory but not simple harmonic
7. Ten capacitors are joined in parallel and charged with a battery up to a potential V. They are then disconnected
from a battery and joined again in series then the potential of this combination will be
A.V B.2V C.5V D.10V
8. Four capacitors of equal capacitance have an equivalent capacitance C 1 when connected in series and an equivalent
capacitance C2 when connected in parallel. The ratio C1/C2 is
A.1/16 B.1/12 C.1/8 D.1/4
9. The condensers of capacity C1 and C2 are connected in parallel, then the equivqlent capacitance is
A. C1+C2 B.C1C2/C1+C2 C. C1/C2 D. C2/C1
10. Thee capacitors each capacitance C and of breakdown voltage V are joined in series. The capacitance and
breakdown voltage of the combination will be
A. C/3,V/3 B.C/3,3V C.3C,V/3 D.3C,3V
11. Resistance is measured in units of
A.volts-meter B.ohms/volt C.ohms D.volts-amperes
12. What will be the total resistance connected in series 9ohms,5ohms,6ohms
A.10ohms B.15 ohms c.20ohms D.21ohms
13. What will be the total resistance connected in parallel
A.5ohms B.10ohms C.15ohms D.20ohms
14. A component that limits the amount of voltage and current in a circuit is
A.Capacitor B. Diode C.Resistor D. Diode
15.What will be the total resistance of 100 ohms and 220ohms connected in series?
A.200 ohms B.250 ohms C.300 ohms D.320ohms
16. What will be the total resistance of 100ohms and 220 ohms connected in parallel?
A.65.77 B.66.77 C.67.77 D.68.77
17. Ohms Law states that
A. I in a circuit is inversely proportional to electromotiveforce
B.I in a circuit is directly proportional to the electromotive force.
C.Electromotive force and resistance are inversely proportional.
D.I ina circuit is directly proportional to resistance
18. A resistance of 11 ohms will allow 10A of current if the electromotive force is
A.0.91 V B.1.1 V C.10V D. 110V
19. What is the resistance of an electric toaster if it takes a current of 5 amperes when connected to a 120-volt
circuit?
A.15ohms B.20ohms C.24ohms D.24ohms
20.The voltage across the terminal of a resistor is 6 volts and ammeter reads 1.5 amp. What is the resistance of the
resistor?
A.2ohms B.3ohms C.4ohms D.5ohms
21.The voltage across the terminals of a resistor is 6.0volts and ammeter connected reads 1.5 amp.What would the
current be if the potential difference were raised to 8.0volts?
A.1A B.2A C.3A D.4A
22.The color sequence in a carbon resistor has the colors orange,blue,green and silver. Its resistance value and
tolerance percentage respectively are
A.36X104ohms and 10% C.35X106 ohms and 5%
5
B.36x10 ohms and 10% D.63X105ohms and 5%
23.The tolerance level of a resistor with the color code red,blue,orange, gold is
A.+/- 5% B.+/-10% C.+/-15% D.+/-20%
24.Electromotive force is most closely related to
A. Electric field B.Magnetic field C.Mechanical force D.Potential difference
25.Electromotive force is the force, which is able to maintain a constant
A. Current B.Potential difference C.Power D.Resistance
26. A cell of electromotive force 6V and a resistance of 0.5 ohm is short circuited, The current in the cell is
A.3amp B.6amp C.12amp D.24 qmp
27. A battery having electromotive force of 5V and internal resistance 0.5 ohms is connected with a resistance of
4.5ohms then the voltage at the terminals of battery is
A.0V B.2V C.4V D.4.5 V
28. If six identical cells each having an electromotive force of 6V are connected in parallel, the emf of the combination
is
A.1/6V B.1V C.6V D.36V
29. All magnets can have
A.two N-seeking poles C.an E- seeking or W-seeking pole
B.two S-seeking D. only the N-seeking and S-seeking poles
30. The force of repulsion or attraction between two poles depends mainly on
A. strength of the poles C. permanence of the magnet
B. Kind of metal is the magnet D.the distance between the poles
31.The magnetic field in a magnet is produced by
A.the moving electrons in a magnet
B. the transfer of protons from one end to another end of a magnet
C. the neutrons moving out of the nuclei of the atoms in the magnet
D. some another forces in the magnet aside from electron, protons, and nuclei
32.The N-pole and the S-pole
A. attract each other C. are neutral with each other
B.push against each other D.have something to do with the nature of a magnet
33. A magnetic field is produced by
A. electric charges at rest C.permanent magnets onlyforce
B.electric charges in motion D. electric charges both at rest and in motion
34.The magnetic induction
A. is the force per unit pole C. exist only for permanent magnets
B.is the force per moving charge D.electric charges both at rest and in motion
35. The direction of the magnetic field in the vicinity of a bar magnet is
A.always toward the north pole at the end of the magnet
B.always away from the south pole at the end of the magnet
C.in the direction the south pole of a compass needle would point
D.in the direction the north pole of a compass would point
36. An induced current in a wire loop
A.can result only from a time-varying magnetic field
B. always decreases when the magnetic flux decreases
C.is in much direction that its effects oppose the change producing it.
D.results from a constant magnetic flux
37. The magnetic flux through a wire loop
A. always decreases when the magnetic flux decreases
B.can result only from a time-varying magnetic field
C.is in such a direction that its effects oppose the change producing it
D. requires a time-varying magnetic field
38. The car of a battery that is connected to the transmission line is an example of
A. Alternating current C..Voltage
B. Direct current D. wattage
39. The power source to our appliances is an example of
A. alternating current C. Voltage
B. Direct current D. Wattage
40. It is connected across the load in accordance with the circuit polarity
A. Alternating current C.Voltage
B. Direct current D.Wattage
41. It is connected across the load regardless of polarity
A. alternating current B. direct current C. Voltage D. Wattage
42. What gate that there is change state of input
A.AND B.NOT C. OR D.NAND
43.If both input in a NAND Gates is O?What will be the output
A.0 B.1 C.1,0 D.0,1
44. If both input in a OR gate is 0. What will be the output
A.0 B.1 C.1,0 D.0,1
45. If both input in a NOR Gates is 0. What will be the output
A.0 B.1 c.0,1 D.1,0
46. If the input is 1 in OR gate. What will be the output
A.0 B.1 C.0,1 D.1,0
47. The output of AND gates is 1
A. If both inputs are 0
B. If both inputs are 1
C. If one input is 0 and the other input is 1
D.Either if both inputs are 1 or if one of the inputs is 1 and the other0
48.The output of OR gate is 1
A. If both inputsbbare zero C.Only if both input are 1
B. if either or both inputs are 1 D.if either input is zero
49. Identify the true statement of OR gate
A.Output Y will be 1 when the input A or B or both are 1
B.Output Y will be 0 when either of the inputs A and B is 1
C.Output Y will be 1 only when both the inputs A and B are 1.
D.Output y will be 1 only when either of the inputs A and B is 1.
50. If the two inputs of a NAND gate are 0 the gate is equivalent to
A. 0 B.1 C.1,O D.0,1