Scribd
Upload
94 views5 pages

Cisco Block Loop

Loopback Detection (LBD) is a feature that protects against loops by sending loop protocol packets when enabled. If a switch port receives the same packet it transmitted, the port will shut down. This helps prevent loops without relying on the Spanning Tree Protocol. The document provides steps to enable LBD on specific switch models and ports, including setting detection intervals, applying settings, and verifying loop detection is enabled on ports.

Uploaded by

osama Os
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views5 pages

Cisco Block Loop

Loopback Detection (LBD) is a feature that protects against loops by sending loop protocol packets when enabled. If a switch port receives the same packet it transmitted, the port will shut down. This helps prevent loops without relying on the Spanning Tree Protocol. The document provides steps to enable LBD on specific switch models and ports, including setting detection intervals, applying settings, and verifying loop detection is enabled on ports.

Uploaded by

osama Os
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Enable Loopback Detection on a Switch

Objective
Loopback Detection (LBD) is a feature that protects against loops by sending out loop protocol
packets when it has loop protection enabled. When the switch transmits a loop protocol packet
and the port receives the same packet, it shuts down the port that received the packet. Although
similar to the Spanning Tree Protocol (STP), LBD is not dependent on STP. The port that received
the loop is put on Shut Down state. A trap is then sent, and then the event logged.

Applicable Devices
● Sx250 Series
● Sx350 Series
● SG350X Series
● Sx550X Series

Software Version
● 2.3.5.63

Enable Loopback Detection on the Switch


Step 1. Choose whether to manage the switch or manage the network.

Note: In this example, Switch Management is chosen.

Step 2. Enter your credentials and then click Log In.


Step 3. Click the Display Mode drop-down list and then choose Advanced.

Step 4. Choose Port Management > Loopback Detection Settings.

Step 5. Check the Loopback Detection Enable check box.


Step 6. Enter the Detection Interval value.

Note: The valid range is from 10 to 60. The default value is 30. In this example, 25 is entered.

Step 7. Click Apply.

Step 8. (Optional) Click Save to save the configuration permanently.


Enable Loopback Detection on the Port

Step 1. On the Loopback Detection Port Setting Table, click the radio button that corresponds to
the port that needs to be configured.

Note: In this example, XG3 is chosen.

Step 2. Click Edit.

Step 3. Check the Loopback Detection State Enable check box.

Step 4. Click Apply.


Step 5. Click Save to save the configuration permanently.

Step 6. Verify that the Loopback Detection Administrative state is enabled.

Step 7. (Optional) Repeat the steps for each port that needs to have LBD enabled.

You should now have successfully enabled loopback detection on your switch.

You might also like