Scribd
Upload
76 views4 pages

2016 ES103 Basic Electrical Engineering

Uploaded by

Ranjeet Singh Bisht
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
76 views4 pages

2016 ES103 Basic Electrical Engineering

Uploaded by

Ranjeet Singh Bisht
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 4
A. aminotes Enrols NO: nsiseroerie (No. of Printed Pages ~ 4] (ET] END SEMESTER EXAMINATION : APRIL-MAY, 2016 BASIC ELECTRICAL ENGINEERING Time: 3 Hrs. Maximum Marks : 70 Note: Attempt questions from all sections as directed. SECTION -A (30 Marks) Attempt any five questions out of six Each question carries 06 marks. 1 Define the following terms : (a) Q-Factor (b) Form Factor « Peak factor (c) RMS values of a ‘nating*current 2. Using Mesh Analysis, tind the voltage drop across 1 Kohm resistor in Fig (a) ae ren Ikea \t0v joov | wn akan Soon P.T.O. ESLON a , Aaminotes Using the Superposition Principle find the volliige across | Kolm resistor in the circuit: shown in Vig, (b). Assume the sources to be ideal, |Iene | sv Ska al State Thevenin’s theorem. Using Thevenin’s theorem find the potential difference across branch AB of the network shown in Fig. (¢). de oy 4a lov Le aa as B « Fig. (¢) (a) What is resonance in series circuits ? (3) stance (b) A coil having an inductance of $0 mH and res of 10 ohm is connected in series with 25 microfarad capacitor across a 200V, 50 Hz a¢ supply. Calculate (i) Resonance Frequency of the circuit Gi) Current flowing at resonance and (iii) Value of Q, by using given data, (3) A. aminotes ES103 3 6. A 230V. 50Hz a.c supply is applied to a coil of 0.06 H inductance and 2.5 ohm resistance connected in series With 6.8 microfarad capacitor. Calculate (i) impedance (11) current (iii) phase angle between current and voltage (iv) power factor (v) power consumed. SECTION - B (20 Marks) Attempt any two questions out of three. Each question carries 10 marks 7. (a) Explain how Power is measured in 3-phase circuits by two wattmeter method ? (5) (b) Three similar coils each having a resistance of Sohm and an inductance of 0.02H are connected in delta to a 440V, 3 phase, 50 Hz supply. Calculate the line currept and tota! power absorbed. (5) 8. (a) Derive the EMF equation of Single Phase Transformer. (5) (b) The maximum Flux density in the core of a 250/ 3000 volts, 50 Hz single phase Transformer is 1.2 Wb m?. If the e.m.f per turn is 6 volt, determine (i) Primary and secondary turns ' (ii) Area of the core «5) P.T.O- A. ominotes 9. (a) Classify DC Generators on the basic of excitation () ES103 4 (b) A Shunt Generator delivers 450 A at 230V and the resistance of the shunt field and armature are 50 ohm and 0.03 ohm respectively. Calculate the generated e.m.f. (S) SE (Compulsory) TION -C (20 Marks) 10. (a) State and explain Maximum Power Transfer Theorem. Also drive condition for maximum power. (4) (b) Two wattmeter method is used to measure the power factor taken by a 3-phase induction motor on no load. The wattmeter readings are 375 W and -50 W. Calculate (i) Power factor of the motor at no load (ii) Phase difference of voltage and current two wattmeters (iii) Reactive power taken by load (c) Describe the construction and workir Permanent Magnet Moving Coil (PMMC) Instruments. ( (d) Give the classification of Elec Me Instruments on the basis of operation es

You might also like