Scribd
Upload
222 views1 page

Datasheet Arduino Nano

The Arduino Nano is a small and breadboard-friendly board based on the ATmega328 or ATmega168 microcontroller. It has similar functionality to the Arduino Duemilanove but uses a Mini-B USB cable instead of a standard cable. The Nano was designed by Gravitech and has 14 digital input/output pins, 8 analog pins, and runs on a 16MHz clock speed while powered through a 7-12V input.

Uploaded by

Ahmad Azriel Daffarisandi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
222 views1 page

Datasheet Arduino Nano

The Arduino Nano is a small and breadboard-friendly board based on the ATmega328 or ATmega168 microcontroller. It has similar functionality to the Arduino Duemilanove but uses a Mini-B USB cable instead of a standard cable. The Nano was designed by Gravitech and has 14 digital input/output pins, 8 analog pins, and runs on a 16MHz clock speed while powered through a 7-12V input.

Uploaded by

Ahmad Azriel Daffarisandi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

...

The Arduino Nano is a small, complete, and breadboard-friendly board based on the ATmega328 (Arduino
Nano 3.0) or ATmega168 (Arduino Nano 2.x). It has more or less the same functionality of the Arduino
Duemilanove, but in a different package. It lacks only a DC power jack, and works with a Mini-B USB cable
instead of a standard one. The Nano was designed and is being produced by Gravitech.

Technical Specification

Microcontroller Atmel ATmega168 or ATmega328


Operating Voltage (logic
5V
level)
Input Voltage (recommended) 7-12 V
Input Voltage (limits) 6-20 V
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 8
DC Current per I/O Pin 40 mA
16 KB (ATmega168) or 32 KB (ATmega328) of which 2 KB used by
Flash Memory
bootloader
SRAM 1 KB (ATmega168) or 2 KB (ATmega328)
EEPROM 512 bytes (ATmega168) or 1 KB (ATmega328)
Clock Speed 16 MHz
Dimensions 0.73" x 1.70"
If you want to give a closer look to this board we advice you to visit the official Arduino Nano page in the
Hardware Section.

You might also like