Code No: 117GQ Set No.

1
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
IV B .Tech. I Sem., II Mid-Term Examinations, November - 2017
POWER SYSTEM OPERATION AND CONTROL
Objective Exam
Name: ______________________________ Hall Ticket No. A
Answer All Questions. All Questions Carry Equal Marks. Time: 20 Min. Marks: 10.

I. Choose the correct alternative:

1. The gain of a speed – governor KG represents: [ ]

a) A position of an assumed linear instantaneous indication of a speed produced by the speed governor.
b) The regulation or droop of speed-governor characteristics.
c) The governor speed-changer position. d) None of these.

2. When the excitation increases, the current______ and the power angle _________. [ ]
a) Increases, increases b) Decreases, increases
c) Increases, decreases d) Decreases, decreases

3. Governors of controlling the speed of electric generating units normally provide: [ ]

a) A flat speed load characteristics b) An increases in speed with an increasing load
c) A decrease in speed with an increasing load d) None

4. KE and frequency of a synchronous machine are related as [ ]

a) KE=f b) KE=1/f c) KE=f2 d) None

5. Transfer functions of non – reheat type of steam turbine is of __________ order. [ ]

a) First b) Second c) Third d) None

6. The block diagram of the LFC of an isolated power system is of ________ model. [ ]
a) First b) Second c) Third d) None

7. The main reason for low p,f, of supply system is due to the use of ______ [ ]
a) Resistive load b) Inductive load c) Synchronous load d) All

8. An over excitation synchronous motor on no load is know as ______________ [ ]

a) Synchronous Induction Generator b) Synchronous Condenser c) Alternator d) None

9. Reactive power is _____________ power [ ]

a) Wattfull b) Wattless c) Loss d) None

10. An uncompensated line on open circuit leads to ______________ [ ]

a) Ferranti effect b) Line charging current flowing into generators is more
c) Both a and b d) None

Cont…..2
Code No:117GQ :2: Set No. 1

II Fill in the Blanks

11. When the excitation increases, the torque angle δ__________________.

12. When the excitation increases, the power angle become _____________with respect to terminal voltage.

13. In an ALFC loop, Δf can be reduced using ____________ controller.

14. _____________ is the basic control mechanism in the power system.

15. Tie-line between two areas usually will be a _____________ line.

16. Dynamic response of a two – area system can be represented by a ____________ order transfer function.

17. The excitation system is mainly classified into _________ category.

18. By improving the p.f. of the system, the Kilowatts delivered by generating station are_______ .

19. Inductive shunt compensation ___________ the virtual surge impedance and ___________ the virtual
SIL of the line.

20. The smaller the lagging reactive power drawn by a circuit, its power factor will be ______ .

-oOo-
Code No: 117GQ Set No. 2
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
IV B .Tech. I Sem., II Mid-Term Examinations, November - 2017
POWER SYSTEM OPERATION AND CONTROL
Objective Exam
Name: ______________________________ Hall Ticket No. A
Answer All Questions. All Questions Carry Equal Marks. Time: 20 Min. Marks: 10.

I. Choose the correct alternative:

1. KE and frequency of a synchronous machine are related as [ ]

a) KE=f b) KE=1/f c) KE=f2 d) None

2. Transfer functions of non – reheat type of steam turbine is of __________ order. [ ]

a) First b) Second c) Third d) None

3. The block diagram of the LFC of an isolated power system is of ________ model. [ ]
a) First b) Second c) Third d) None

4. The main reason for low p,f, of supply system is due to the use of ______ [ ]
a) Resistive load b) Inductive load c) Synchronous load d) All

5. An over excitation synchronous motor on no load is know as ______________ [ ]

a) Synchronous Induction Generator b) Synchronous Condenser c) Alternator d) None

6. Reactive power is _____________ power [ ]

a) Wattfull b) Wattless c) Loss d) None

7. An uncompensated line on open circuit leads to ______________ [ ]

a) Ferranti effect b) Line charging current flowing into generators is more
c) Both a and b d) None

8. The gain of a speed – governor KG represents: [ ]

a) A position of an assumed linear instantaneous indication of a speed produced by the speed governor.
b) The regulation or droop of speed-governor characteristics.
c) The governor speed-changer position. d) None of these.

9. When the excitation increases, the current______ and the power angle _________. [ ]
a) Increases, increases b) Decreases, increases
c) Increases, decreases d) Decreases, decreases

10. Governors of controlling the speed of electric generating units normally provide: [ ]
a) A flat speed load characteristics b) An increases in speed with an increasing load
c) A decrease in speed with an increasing load d) None

Cont…..2
Code No:117GQ :2: Set No. 2

II Fill in the Blanks

11. _____________ is the basic control mechanism in the power system.

12. Tie-line between two areas usually will be a _____________ line.

13. Dynamic response of a two – area system can be represented by a ____________ order transfer function.

14. The excitation system is mainly classified into _________ category.

15. By improving the p.f. of the system, the Kilowatts delivered by generating station are_______ .

16. Inductive shunt compensation ___________ the virtual surge impedance and ___________ the virtual
SIL of the line.

17. The smaller the lagging reactive power drawn by a circuit, its power factor will be ______ .

18. When the excitation increases, the torque angle δ__________________.

19. When the excitation increases, the power angle become _____________with respect to terminal voltage.

20. In an ALFC loop, Δf can be reduced using ____________ controller.

-oOo-
Code No: 117GQ Set No. 3
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
IV B .Tech. I Sem., II Mid-Term Examinations, November - 2017
POWER SYSTEM OPERATION AND CONTROL
Objective Exam
Name: ______________________________ Hall Ticket No. A
Answer All Questions. All Questions Carry Equal Marks. Time: 20 Min. Marks: 10.

I. Choose the correct alternative:

1. The block diagram of the LFC of an isolated power system is of ________ model. [ ]
a) First b) Second c) Third d) None

2. The main reason for low p,f, of supply system is due to the use of ______ [ ]
a) Resistive load b) Inductive load c) Synchronous load d) All

3. An over excitation synchronous motor on no load is know as ______________ [ ]

a) Synchronous Induction Generator b) Synchronous Condenser c) Alternator d) None

4. Reactive power is _____________ power [ ]

a) Wattfull b) Wattless c) Loss d) None

5. An uncompensated line on open circuit leads to ______________ [ ]

a) Ferranti effect b) Line charging current flowing into generators is more
c) Both a and b d) None

6. The gain of a speed – governor KG represents: [ ]

a) A position of an assumed linear instantaneous indication of a speed produced by the speed governor.
b) The regulation or droop of speed-governor characteristics.
c) The governor speed-changer position. d) None of these.

7. When the excitation increases, the current______ and the power angle _________. [ ]
a) Increases, increases b) Decreases, increases
c) Increases, decreases d) Decreases, decreases

8. Governors of controlling the speed of electric generating units normally provide: [ ]

a) A flat speed load characteristics b) An increases in speed with an increasing load
c) A decrease in speed with an increasing load d) None

9. KE and frequency of a synchronous machine are related as [ ]

a) KE=f b) KE=1/f c) KE=f2 d) None

10. Transfer functions of non – reheat type of steam turbine is of __________ order. [ ]
a) First b) Second c) Third d) None

Cont…..2
Code No:117GQ :2: Set No. 3

II Fill in the Blanks

11. Dynamic response of a two – area system can be represented by a ____________ order transfer function.

12. The excitation system is mainly classified into _________ category.

13. By improving the p.f. of the system, the Kilowatts delivered by generating station are_______ .

14. Inductive shunt compensation ___________ the virtual surge impedance and ___________ the virtual
SIL of the line.

15. The smaller the lagging reactive power drawn by a circuit, its power factor will be ______ .

16. When the excitation increases, the torque angle δ__________________.

17. When the excitation increases, the power angle become _____________with respect to terminal voltage.

18. In an ALFC loop, Δf can be reduced using ____________ controller.

19. _____________ is the basic control mechanism in the power system.

20. Tie-line between two areas usually will be a _____________ line.

-oOo-
Code No: 117GQ Set No. 4
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
IV B .Tech. I Sem., II Mid-Term Examinations, November - 2017
POWER SYSTEM OPERATION AND CONTROL
Objective Exam
Name: ______________________________ Hall Ticket No. A
Answer All Questions. All Questions Carry Equal Marks. Time: 20 Min. Marks: 10.

I. Choose the correct alternative:

1. An over excitation synchronous motor on no load is know as ______________ [ ]

a) Synchronous Induction Generator b) Synchronous Condenser c) Alternator d) None

2. Reactive power is _____________ power [ ]

a) Wattfull b) Wattless c) Loss d) None

3. An uncompensated line on open circuit leads to ______________ [ ]

a) Ferranti effect b) Line charging current flowing into generators is more
c) Both a and b d) None

4. The gain of a speed – governor KG represents: [ ]

a) A position of an assumed linear instantaneous indication of a speed produced by the speed governor.
b) The regulation or droop of speed-governor characteristics.
c) The governor speed-changer position. d) None of these.

5. When the excitation increases, the current______ and the power angle _________. [ ]
a) Increases, increases b) Decreases, increases
c) Increases, decreases d) Decreases, decreases

6. Governors of controlling the speed of electric generating units normally provide: [ ]

a) A flat speed load characteristics b) An increases in speed with an increasing load
c) A decrease in speed with an increasing load d) None

7. KE and frequency of a synchronous machine are related as [ ]

a) KE=f b) KE=1/f c) KE=f2 d) None

8. Transfer functions of non – reheat type of steam turbine is of __________ order. [ ]

a) First b) Second c) Third d) None

9. The block diagram of the LFC of an isolated power system is of ________ model. [ ]
a) First b) Second c) Third d) None

10. The main reason for low p,f, of supply system is due to the use of ______ [ ]
a) Resistive load b) Inductive load c) Synchronous load d) All

Cont…..2
Code No:117GQ :2: Set No. 4

II Fill in the Blanks

11. By improving the p.f. of the system, the Kilowatts delivered by generating station are_______ .

12. Inductive shunt compensation ___________ the virtual surge impedance and ___________ the virtual
SIL of the line.

13. The smaller the lagging reactive power drawn by a circuit, its power factor will be ______ .

14. When the excitation increases, the torque angle δ__________________.

15. When the excitation increases, the power angle become _____________with respect to terminal voltage.

16. In an ALFC loop, Δf can be reduced using ____________ controller.

17. _____________ is the basic control mechanism in the power system.

18. Tie-line between two areas usually will be a _____________ line.

19. Dynamic response of a two – area system can be represented by a ____________ order transfer function.

20. The excitation system is mainly classified into _________ category.

-oOo-