Scribd
Upload
181 views7 pages

Udm Etap

Script blocks in UDM are written in C# and allow models to communicate and transfer setpoints. The UDM master controller can control generation and load shedding in a microgrid, which is a power system that can operate independently from the main grid. This master controller uses new go to blocks to create communication channels where it can transfer operating information to the transient stability engine to generate disturbances for modeling different scenarios.

Uploaded by

yeprem82
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
181 views7 pages

Udm Etap

Script blocks in UDM are written in C# and allow models to communicate and transfer setpoints. The UDM master controller can control generation and load shedding in a microgrid, which is a power system that can operate independently from the main grid. This master controller uses new go to blocks to create communication channels where it can transfer operating information to the transient stability engine to generate disturbances for modeling different scenarios.

Uploaded by

yeprem82
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 7

Script block in UDM is in C# (C sharp)

Microgrid: Microgrid is a power system which can operate in islanded mode, not connected to the grid.
To have its frequency and voltage support, it must be able to operate to transients introduced by
renewable energy sources in the system.

In ETAP 16, there is the ability to simulate master controller. The master controller will control the
generation and the load that will be shed from the system.
The master controller (above) can be created in UDM and take advantage of new go to blocks. This go to
blocks can create internal communication channels where they can create external communication
channel allowing UDM models to communicate and transfer setpoints and operating points. At the same
time the models can transfer information which can be used by the transient stability engine to
generate disturbances in the voltage, frequency and generation in different component in the system.

You might also like