Scribd
Upload
61 views

Introduction of Sound Sensor KY038 On An Arduino

This document provides information about using a KY-038 sound sensor with an Arduino. The sensor detects noise using a microphone and outputs a signal. It has analog and digital outputs that can be connected to an Arduino. The sensitivity of the sensor can be adjusted using a potentiometer to set a threshold noise level that triggers the digital output. The sensor is well-suited for applications requiring threshold-based sound detection and activation of outputs.

Uploaded by

Thành Đạt Thái Nguyễn
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
61 views

Introduction of Sound Sensor KY038 On An Arduino

This document provides information about using a KY-038 sound sensor with an Arduino. The sensor detects noise using a microphone and outputs a signal. It has analog and digital outputs that can be connected to an Arduino. The sensitivity of the sensor can be adjusted using a potentiometer to set a threshold noise level that triggers the digital output. The sensor is well-suited for applications requiring threshold-based sound detection and activation of outputs.

Uploaded by

Thành Đạt Thái Nguyễn
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

Sound Sensor on an Arduino

Though this tutorial is based exclusively on the usage of Sound sensor such as the KY-038,
other tutorials may make usage of these sound sensors associated with other sensors that may
be the focus of those tutorials

A. KY038
Introduction

Fig 1. Test circuit


The KY038 sound sensors have been manufactured to be user friendly when connected to an
Arduino or other microcontrollers. This sensor emits a signal if the front microphone of the sensor
perceives a noise. This sensor emits a signal if the microphone of the sensor detects a noise.

KY038
Here are the specifications:
Specifications:
Model: KY-038

Adopt LM393 main chip

Electric condenser microphone

Features Single channel signal output

Low level output signal used for sound control light

Great module for sound alarm system

Working voltage: DC 4-6V

Interface definition:
AO: analog output sensor

GND: ground

VCC: Power supply input range: 3V-24V.

DO: Digital Output (comparator output)

Two red LED indication: POWER and SENSOR. POWER: Power is off. SENSOR: When the
microphone senses sound reaches a certain value, this LED light.

Connecting with Arduino:


 Pin + to Arduino 5+

 Pin – to Arduino –
 Pin A0 to Arduino A0 (for analog program)
 Pin D0 to Arduino 13 (for digital program)
This sensor emits a signal if the microphone of the sensor detects a noise. The sensitivity of the
sensor can be adjusted by means of a controller.

NOTE ON USE
This sensor is ideally suited for threshold measurement. This means that the sensor emits a
digital high signal as soon as a threshold value set by the user is exceeded. However, this also
means that the analog measured values are not suitable for conversions, as the analog signal is
also influenced by the rotary potentiometer.

Digital output: Via the potentiometer, a limit value for the received sound can be set, at which
the digital output should switch.

FUNCTION OF THE SENSOR


This sensor has three functional components on its circuit board: The front sensor unit, which
physically measures the environment and outputs it as an analog signal to the second unit, the
amplifier. This amplifies the signal depending on the resistance set on the rotary potentiometer
and sends it to the analog output of the module.

Here it is to be noted: The signal is inverted. If a high value is measured, this results in a lower
voltage value at the analog output.

The third unit represents a comparator, which switches the digital output and the LED when the
signal falls below a certain value. This value (and thus the sensitivity of the module) can be
adjusted via the rotary potentiometer:
PIN ASSIGNMENT

You might also like