5 Channel IR Remote Control System Using Microcontroller
5 Channel IR Remote Control System Using Microcontroller
Project Proposal
5 Channel IR Remote Control System using Microcontroller
Group Members
Introduction
Our aim is to design and demonstrate a simple 5 channel remote control system to drive five
loads. The input signals or the commands are sent from a transmitter using IR transmission and
received by the IR receiver, processed and used to drive the loads. At both the transmitter and
receiver, a microcontroller is used to process the signals.
SSUET Page 2
Optoelectronics Project Proposal
R1 – 1M
R2 – 10k
R3 – 760Ohms
R4 – 1.5K
R5 – 100Ohms
C1, C2 – 15pF
C3 – 10uF
C4 – 0.01uF
C5 – 0.1uF
S1 – 5 DIP switch
U1 – AT89C51
U2 – HT12E
U3 – LM555
U4A – 7408 (AND gate)
Q1 – BC547
SSUET Page 3
Optoelectronics Project Proposal
R1 – 100Ohms
R2 – 50K
R3 – 10K
C1 – 10uF
C3, C2 – 10uF
V1 – 5V
U1 – HT12D
U2 – AT89C51
U3 – ULN2004
Q1 – BC547
J1, J2, J3, J4, J5
http://letslearnelectronics.blogspot.com/2012/07/introduction-to-encoding-and-decoding_1610.html
http://www.engineersgarage.com/mygarage/infrared-remote-control-system-project
SSUET Page 4