Scribd
Upload
189 views2 pages

Training On Enercon Generator Control Panel

The document outlines a 40-hour, 5-day training on an Enercon generator control panel. The training will cover an overview of the control system, identifying components and operation philosophy on day 1. Day 2 focuses on the controller's description and operation as well as introducing the HMI. Day 3 introduces interconnects of the control system and basic troubleshooting. Day 4 involves operating the control panel while loaded and monitoring. Day 5 is for alarm and fault analysis, operation management, and troubleshooting and maintenance.

Uploaded by

Mahmudur Rahman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
189 views2 pages

Training On Enercon Generator Control Panel

The document outlines a 40-hour, 5-day training on an Enercon generator control panel. The training will cover an overview of the control system, identifying components and operation philosophy on day 1. Day 2 focuses on the controller's description and operation as well as introducing the HMI. Day 3 introduces interconnects of the control system and basic troubleshooting. Day 4 involves operating the control panel while loaded and monitoring. Day 5 is for alarm and fault analysis, operation management, and troubleshooting and maintenance.

Uploaded by

Mahmudur Rahman
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Training on Enercon Generator Control Panel

Duration : 40 Hours (05 Day)


Location: At site.
Trained by: Enercon Asia Pte. Ltd.
Training summary:

Schedule Content Duration


Day-01 - Over view of Control system 08 hours.
- Device/component identity
- Operation philosophy
- Question review
Day-02 - Controller’s description 08 hours
- Controller’s operation
-HMI introduction
- Question review
Day-03 -Introduction with interconnections of control 08 hours
system.
-Introduction with control design for basic
troubleshooting.
- Question review

Day-04 -Operation of control panel at On-load 08 hours


-Observation and monitoring at On- load
- Question review

Day-05 -Alarm and Fault analysis 08 hours


-Operation Management
-Troubleshooting and Maintenance
- Question review

You might also like