Scribd
Upload
96 views2 pages

Assignment-Engineering Curve Module-I

The document contains 11 assignments related to constructing and analyzing various curves using engineering drawing techniques. The assignments involve drawing ellipses using different methods, inscribing ellipses and parabolas in rectangles, tracing the path of a ball and rolling objects, constructing hypocycloids and involutes, and explaining common curves like circles, ellipses, parabolas, and hyperbolas.

Uploaded by

Rajesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
96 views2 pages

Assignment-Engineering Curve Module-I

The document contains 11 assignments related to constructing and analyzing various curves using engineering drawing techniques. The assignments involve drawing ellipses using different methods, inscribing ellipses and parabolas in rectangles, tracing the path of a ball and rolling objects, constructing hypocycloids and involutes, and explaining common curves like circles, ellipses, parabolas, and hyperbolas.

Uploaded by

Rajesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Assignment-Engineering Curve (Module-I)

Subject-Engineering Graphics (BT-105)


1. Draw an ellipse by concentric circle method given the major and minor axes as
80 mm and 50 mm respectively.
2. Construct an ellipse having in major axis 100 mm and minor axis 80 mm by arc of
circle method.
3. A Plot of ground is in the shape of a rectangle 110 m ×50 m. Inscribe an elliptical
lawn in it by.
4. Draw an ellipse when the distance of its Focus from directrix is equal to 60 mm
and eccentricity is 3/5.
5. A ball through from the ground level reaches a maximum height of 5 m and
travels a horizontal distance of 11 m from the point of projection. Trace the path
of the ball.
6. Inscribe a parabola in a rectangle of sides 100mm×80mm with the longer side as
the base.
7. A coin 40 mm diameter rolls over a dining table without sleeping a point on the
circumference of the coin is in contact with the table surface in the beginning and
after one complete revolution. Draw the curve traced by the point and also draw
the normal and tangent on it.
8. A cycle wheel of 50 cm diameter rolls over a culvert of 175 cm diameter. Draw
the path traced out by a point on the circumference of the cycle wheel for one
complete revolution. Also draw normal and tangent.
9. Construct a hypocycloid, rolling circle 50 mm diameter and directing circle 175
mm diameter. Draw a tangent to it a point 50 mm from the center of directing
circle.
10. Construct an involute curve for 70 mm diameter of circle. Also draw normal and
tangent on it
11. Explain the following-
a.Circle b.Ellipse c.Parabola d.Hyperbola e.Cycloid f.Epicycloid g.Hypocycloid

You might also like