Scribd
Upload
307 views6 pages

Catapult Card Assembly Guide

This document provides assembly instructions for a catapult card in 3 or fewer sentences: The parts list identifies the 12 parts needed to assemble the catapult including the arm, base, springs, and sides. The instructions explain how to assemble the sides by inserting the short end of pins into holes and adding springs, then attach the assembled sides and arm to the base by tapping pins into holes with a hammer. Finally, the top support is added to complete the catapult.

Uploaded by

Magician Peru
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
307 views6 pages

Catapult Card Assembly Guide

This document provides assembly instructions for a catapult card in 3 or fewer sentences: The parts list identifies the 12 parts needed to assemble the catapult including the arm, base, springs, and sides. The instructions explain how to assemble the sides by inserting the short end of pins into holes and adding springs, then attach the assembled sides and arm to the base by tapping pins into holes with a hammer. Finally, the top support is added to complete the catapult.

Uploaded by

Magician Peru
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Catapult Card

Assembly Guide

Page 0 / 5
Remove parts from the card.

Use some wire cutters, small scissors, or a cutting board


and a sharp knife.

10 2
4

12

7 5

8 1

9
3 11

Parts List Parts List Parts List


Item Part Number Item Part Number Item Part Number
1 ArmSupport 5 PinLeft 9 SpringLeft2
2 Arm 6 SpringLeft1 10 SpringRight2
3 Base 7 SpringRight1 11 SideLeft
4 PinRight 8 SideRight 12 TopSupport

Page 1 / 5
Assemble the sides.
The short end of the pins go into the square hole in the
sides, then the springs go onto the pins. Match the
direction of the springs to those shown in the drawing.

Assemble the arm, arm support and sides.

Line up the arm support


with the corresponding hole,
and the pins on the arm with
the spring holes and push
together. Do the same with
the opposite side.

Page 2 / 5
Assemble the base and sides/arm - assembly.
Line up the sides with the base. The base is flat on the
bottom, on the top side there’s a small depression
around the holes.

Top Side Depression

Place on a flat table, tap with a hammer as indicated in


the drawing below, do this on both sides until the back
pins are about halfway located.

Tap here

Table
Back pins

Page 3 / 5
Continued...

Turn the catapult over and position on the edge of a


table as shown below and tap the front of the base onto
the front pins. You should locate the front pins fully, so
that the ends are almost flush with the base underneath.

Tap here

Table Edge

Next turn back over and tap the back legs all the way in,
the sides should now be fully located in the base.

Page 4 / 5
Add the top Support to complete!
Same as with the base line it up as below, the angle on
the front should match the angle on the front of the
sides, you may need to tap this on with a hammer, a bit
at a time on each side.

Tap Here

Assemble the target, then have some fun!


The feet are friction fit so they just need attatching to the
bottom of the target so they stand it up.

Enjoy,
Adam M
Page 5 / 5

You might also like