Scribd
Upload
116 views1 page

Racerstar Programme Card

This document provides instructions for programming an electronic speed controller (ESC) using a programmer card. It lists 5 programmable features: 1) Low voltage cutoff voltage, 2) Start mode aggressiveness, 3) Maximum brake force, 4) Maximum reverse force, and 5) Neutral range. It describes how to connect the programmer card to the ESC, select features and values using the arrow keys, and confirm selections with the program key. Pressing the reset key restores all settings to factory defaults.

Uploaded by

emiliqn velikov
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
116 views1 page

Racerstar Programme Card

This document provides instructions for programming an electronic speed controller (ESC) using a programmer card. It lists 5 programmable features: 1) Low voltage cutoff voltage, 2) Start mode aggressiveness, 3) Maximum brake force, 4) Maximum reverse force, and 5) Neutral range. It describes how to connect the programmer card to the ESC, select features and values using the arrow keys, and confirm selections with the program key. Pressing the reset key restores all settings to factory defaults.

Uploaded by

emiliqn velikov
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

programme card Appearance description BEC interface

Low Voltage cut-off

start modes

Max brake force

Max reverse force


Neutral range

green LED working


condition

Down key Restore factory


settings key

Right key Program key

1：Low Voltage Cut-Off: The function is mainly to prevent the lithium battery pack from over discharging.
When using lithium battery pack, please set the suitable value for low-voltage protection as your like. WARNING:
Never use the default value “Non-protection” for lithium battery! 3.1V、2.8V、3.3V、Non-Protection
（default value 3.1V）。
2 ： 3 start modes (Also called “Punch”) from “soft” to “very aggressive” （ default value
Medium）
3 ： Maximum brake force: （ 25A 、 45A 、 60A ） 50% ， 25% ， 75% ， 100% （ default value
50%），（80A、120A）25%，50%，75%，100%（default value 25%）。
4：Maximum reverse force: 25%，50%，75%，100%（default value 25%）
5：Neutral range: 9%(narrow)，6%(Normal)，12%(Wide) （default value 9%）
programme card Method：
1. Connect BEC wires with the programmer then turn on the ESC.（80A、120A press the keys to be
not put）
2. The Green LED flashes for 2 times then LED off, that is, the connecting programmer with ESC is
successful, and the Red LED on presents the current value of that item. Otherwise, the connecting is
failed.
3. Please press the Key “↓” to select different programs
4. Please press the Key “→” to select different value of the current program
5. Please press the Key “Program” to confirm above selections, the Green LED on immediately and
has gone out within 5 seconds, that is, this process is successful.
6. Please press the Key “Reset” to reset the factory setting.

You might also like