Module 7-9
Module 7-9
During which two steps will the client PC use broadcast messages when communicating with a DHCP server? (Choose two.)
DHCPDISCOVER
DHCPREQUEST
2. An administrator issues the commands:
What is the administrator trying to achieve?
The client may have received offers from multiple servers, and the broadcast serves to implicitly decline those other offers.
4. Which DHCP IPv4 message contains the following information?
Destination address: 255.255.255.255
Client IPv4 address: 0.0.0.0
Default gateway address: 0.0.0.0
Subnet mask: 0.0.0.0
DHCPDISCOVER
5. Place the options in the following order:
DHCP
67
7. Refer to the exhibit. PC1 is configured to obtain a dynamic IP address from the DHCP server. PC1 has been shut down for two weeks. When PC1 boots and tries to request an available IP address, which destination IP
address will PC1 place in the IP header?
192.168.1.1
255.255.255.255
8. Which message does an IPv4 host use to reply when it receives a DHCPOFFER message from a DHCP server?
DHCPREQUEST
9. Which command, when issued in the interface configuration mode of a router, enables the interface to acquire an IPv4 address automatically from an ISP, when that link to the ISP is enabled?
ip address dhcp
10. Which kind of message is sent by a DHCP client when its IP address lease has expired?
DHCPACK
12. What is one indication that a Windows computer did not receive an IPv4 address from a DHCP server?
broadcast DHCPREQUEST
14. A small coffee shop is offering free Wi-Fi to customers. The network includes a wireless router and a DSL modem that is connected to the local phone company. What method is typically used to configure the
connection to the phone company?
67
68
16. A client device on an Ethernet segment needs an IP address in order to communicate on the network. A DHCP server with IP address 192.168.1.1 has been configured and enabled on the network. How will a client
device obtain a usable IP address for this network?
When a device that is configured to use DHCP boots, the client broadcasts a DHCPDISCOVER message to identify any available DHCP servers on the network.
20. A network administrator configures a router to send RA messages with M flag as 0 and O flag as 1. Which statement describes the effect of this configuration when a PC tries to configure its IPv6 address?
It should use the information that is contained in the RA message and contact a DHCPv6 server for additional information.
21. Refer to the exhibit. What should be done to allow PC-A to receive an IPv6 address from the DHCPv6 server?
the link-local address of the router interface that is attached to the network
25. Refer to the exhibit. A network administrator is configuring a router for DHCPv6 operation. Which conclusion can be drawn based on the commands?
GLBP
28. Refer to the exhibit. A network engineer is troubleshooting host connectivity on a LAN that uses a first hop redundancy protocol. Which IPv4 gateway address should be configured on the host?
192.168.2.100
29. Refer to the exhibit. Which destination MAC address is used when frames are sent from the workstation to the default gateway?
The host sends an ICMPv6 neighbor solicitation message to the DHCP or SLAAC-learned address and if no neighbor advertisement is returned, the address is considered unique.
35. Which statement describes HSRP?
It is used within a group of routers for selecting an active device and a standby device to provide gateway services to a LAN.
36.Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
What is the keyword that is displayed on www.netacad.com?
Router
43. The address pool of a DHCP server is configured with 192.168.234.0/27. The network administrator reserves 22 IP addresses for IP phones. How many IP addresses are left in the pool to be assigned to other hosts?
8
44. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is set as 5 days. An employee returns to the office after an absence of one week. When the
employee boots the workstation, it sends a message to obtain an IP address. Which Layer 2 and Layer 3 destination addresses will the message contain?
FF-FF-FF-FF-FF-FF and 255.255.255.255
45. Which command will allow a network administrator to check the IP address that is assigned to a particular MAC address?
the IPv4 addresses that are assigned to hosts by the DHCP server
48. What is the result of a network technician issuing the command ip dhcp excluded-address 10.0.15.1 10.0.15.15 on a Cisco router?
The Cisco router will exclude 15 IP addresses from being leased to DHCP clients.
50. Refer to the exhibit. Based on the output that is shown, what kind of IPv6 addressing is being configured?
stateless DHCPv6
51. Which FHRP implementation is a Cisco-proprietary protocol that suppports IPv6 load balancing
Workstations are assigned with IP addresses in the 169.254.0.0/16 network.Workstations are assigned with the IP address 0.0.0.0.
54. A company uses the method SLAAC to configure IPv6 addresses for the workstations of the employees. A network administrator configured the IPv6 address on the LAN interface of the router. The
interface status is UP. However, the workstations on the LAN segment did not obtain the correct prefix and prefix length. What else should be configured on the router that is attached to the LAN
segment for the workstations to obtain the information?
IRDP
56. Refer to the exhibit. PC-A is unable to receive an IPv6 address from the stateful DHCPv6 server. What is the problem?
The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation.
HSRP for IPv6
59. Which FHRP implementation is a nonproprietary IPv4-only election protocol which has one master router per group?
VRRPv2
60. The address pool of a DHCP server is configured with 172.18.93.0/25. The network administrator reserves 10 IP addresses for web servers. How many IP addresses are left in the pool to be assigned to other hosts?
116
61. The address pool of a DHCP server is configured with 10.3.2.0/24. The network administrator reserves 3 IP addresses for printers. How many IP addresses are left in the pool to be assigned to other hosts?
251
62. The address pool of a DHCP server is configured with 172.23.143.0/26. The network administrator reserves 14 IP addresses for file servers. How many IP addresses are left in the pool to be assigned to other hosts?
48
63. The address pool of a DHCP server is configured with 10.7.30.0/24. The network administrator reserves 5 IP addresses for printers. How many IP addresses are left in the pool to be assigned to other hosts?
249
64. Which FHRP implementation is a nonproprietary IPv4-only election protocol with limited scalability?
VRRPv2
65. The address pool of a DHCP server is configured with 192.168.184.0/26. The network administrator reserves 18 IP addresses for access points. How many IP addresses are left in the pool to be assigned to other hosts?
44
66. The address pool of a DHCP server is configured with 10.19.44.0/24. The network administrator reserves 3 IP addresses for servers. How many IP addresses are left in the pool to be assigned to other hosts?
251
67. The address pool of a DHCP server is configured with 10.19.44.0/24. The network administrator reserves 6 IP addresses for servers. How many IP addresses are left in the pool to be assigned to other hosts?
248
68. The address pool of a DHCP server is configured with 172.21.121.0/25. The network administrator reserves 12 IP addresses for web servers. How many IP addresses are left in the pool to be assigned to other hosts?
114