Brushbond Flex
Brushbond Flex
Brushbond Flex
Uses
Water absorption
Brushbond FLex is a two component polymer modified Spalled and deeply disintegrated concrete should be
cementitious coating which is supplied in ready mix kits. removed to sound concrete and repaired with Renderoc
When mixed, and easy brushable coating is produced. It
can simply be applied by a stiff brush, roller or trowel to System.
Page 1
2
BRUSHBOND FLEX
Application Coverage
2
For best results, damp the surfaces before coating with The approximate coverage at 1.25 m per kg for single
Brushbond Flex. Use a short, stiff bristle brush preferably coatings application. Allowance should be made for any
120 to 200 mm in width, apply like a paint using one or possible waste when estimates the consumption.
Brushbond Flex should be applied to the recommended Gloves and googles should be worn. Any splashes to the
coverage. It is recommended for general re-surfacing that skin or eyes should be washed off with clean water. In the
each coat should be minimum 1 mm thickness and an event of prolonged irritation, seek medical advice.
additional 2 mm coating will be required for areas of Powder product should be handled to minimise dust
moderate to heavy pedestrian conditions. formation, use a light mask if excessive dust unavoidable.
Cleaning Storage
Brushbond Flex should be removed from tools and Brushbond Flex has a shelf life of 12 months in unopened
o
equipments immediately after use with clean water. pack with storage temperature 25-35 C,
Hardened material can only be removed mechanically. RH: 55-65%. Avoid stored in outside area.
Packaging to 6 months.
Important note
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard Conditions for the
PT.FOSROC Supply of Goods and Services, copies of which may be obtained on request. Whilst Fosroc endeavours to ensure that any advice,
recommendation, specification of information it may give is accurate and correct, it cannot, because it has no direct or continuous control
Indonesia over where or how its products are applied, accept any liability either directly or indirectly arising from the use of its products, whether or
not in accordance with any advice, specification, recommendation of information given by it.
Page 2