Analysis of Circuits June-10

Reg. No.
Question Paper Code: E3081
B.E./B.Tech. DEGREE EXAMINATION, JUNE 2010 Second Semester
Electrical and Electronics Engineering EE2151 CIRCUIT THEORY
(Common to Instrumentation & Control Engineering and Electronics & Instrumentation Engineering) (Regulation 2008)
Answer ALL Questions
21
the b
Figure 1 Figure 2
Time : Three hours
PART A (10 2 = 20 Marks) 1. In the figure 1 shown, find the value of I.
ew n
ww
2.
Find the equivalent resistance between A and B in figure 2.
21
4
gra w.
4
Maximum : 100 Marks
om .c
21
3.
Find the equivalent current source for the circuit shown in figure 3.
Figure 3 4. 5.
State maximum power transfer theorem in a dc circuit.
In a series RLC circuit, if the value of L and C are 100 H and 0.1 f respectively, find the resonance frequency in HZ.
6.
In a coupled circuit having two coils, the value of L1 , L2 and K are 5 mH,
mutual inductance between the two coils. 7.
21
the b
Figure 9
10 mH and 0.8 respectively where K is the coefficient of coupling. Find the
A series RL circuit with R = 100 and L = 20H has a dc voltage of 200V
applied through a switch at t = 0 . Assuming the initial current through the inductor at t = 0 is zero, find the current at t = 0.5 sec. 8.
ew n
What is the condition to be present in a series RLC circuit to make the circuit critically damped?
9.
In the circuit shown in figure 9, find the rms value of line current and phase voltage.
ww
21
4
gra w.
2
4
om .c
21
E 3081
10.
In the circuit shown in figure 10, find the total power consumed by the 3
Figure 10
PART B (5 16 = 80 Marks) 11. (a) In the circuit shown in figure 11 (a), find the different mesh currents, power delivered by each source and the current through RL. (16)
21
(b)
In the circuit shown in figure 11 (b), find the different node voltages and the currents I1 , I 2 and I 3 . (16)
ww
21 4
4
gra .
Or 3
Figure 11 (a)
the b
ew n
Figure 11 (b)
4
om .c
E 3081
21
load.
12.
(a)
In the circuit shown in figure 12 (a), find (i) (ii) the equivalent resistance between P and Q. the total current from the 240V source.
(iii) the current through the 18 resistor.
Figure 12 (a) Or (b) (i) In the following circuit shown in figure 12 (b), (i) find the current through 5 by Thevenins theorem.
21
Figure 12 (b) (i)
4
(8) (ii) Find the value of RL at which maximum power is transferred to
RL and hence the maximum power transferred to RL in the circuit
ww
shown in figure 12 (b) (ii).
4
gra w.
4
the b
ew n
om .c
21
Figure 12 (b) (ii)
21
(7) (2) (7) (8)
E 3081
13.
(a)
Or (b)
In the circuit shown in figure 13 (b), find the value of I1 and I 2 and also the real power supplied by each source. (16)
Figure 13 (b) 14. (a) In the circuit shown in figure 14 (a), the switch S is closed at time t = 0 in position 1 and changed over to position 2 after one millisecond. Find the time at which the current is zero and reversing its direction. Assume that the change over of switch from position 1 to 2 takes place in zero time.
21
the b
Figure 14 (a) Or Figure 14 (b) 5
ew n
(b)
In the circuit shown in figure 14 (b), find the expression for current if the switch is closed at t = 0 and the value of current at t = 1 millisecond. Assume initial charge on the capacitor is zero. (16)
ww
21
4
gra w.
4
om .c
E 3081
21
A series RLC circuit with R = 10 , L = 10 mH and C = 1 f has an applied voltage of 200 V at resonance frequency. Calculate the resonant frequency, the current in the circuit and the voltage across the elements at resonance. Find also the quality factor and band width for the circuit. (16)
15.
(a)
(i)
(ii)
Determine the line currents for the unbalanced delta connected load shown in figure 15 (a) (ii) phase sequence is RYB. (8)
Figure 15 (a) (ii)
(b)
An unbalanced star-connected load is supplied from a 3 , 440V , symmetrical system. Determine the line currents and the power input to the circuit shown in figure 15 (b). Assume RYB sequence. Take phase voltage VRn as reference in the supply side. (16)
21
the b
Figure 15 (b) 6
Or
ew n
ww
21
4
gra w.
4
om .c
E 3081
21
Two wattmeters are connected to measure the power in a 3 , 3 wire balanced load. Determine the total power and power factor if the two wattmeters read (1) 1000 w each, both positive (2) 1000 w each, of opposite sign. (8)

Analysis of Circuits June-10

Uploaded by

Copyright:

Available Formats

Analysis of Circuits June-10

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Analysis of Circuits June-10

Uploaded by

Copyright:

Available Formats

Reg. No.

Question Paper Code: E3081

B.E./B.Tech. DEGREE EXAMINATION, JUNE 2010 Second Semester

Electrical and Electronics Engineering EE2151 CIRCUIT THEORY

Answer ALL Questions

Time : Three hours

PART A (10 2 = 20 Marks) 1. In the figure 1 shown, find the value of I.

Find the equivalent resistance between A and B in figure 2.

State maximum power transfer theorem in a dc circuit.

mutual inductance between the two coils. 7.

10 mH and 0.8 respectively where K is the coefficient of coupling. Find the

A series RL circuit with R = 100 and L = 20H has a dc voltage of 200V

(iii) the current through the 18 resistor.

shown in figure 12 (b) (ii).

Figure 12 (b) (ii)

Figure 15 (a) (ii)

You might also like