Cambridge International AS & A Level: Mathematics 9709/13 May/June 2022
Cambridge International AS & A Level: Mathematics 9709/13 May/June 2022
Cambridge International AS & A Level: Mathematics 9709/13 May/June 2022
MATHEMATICS 9709/13
Paper 1 Pure Mathematics 1 May/June 2022
MARK SCHEME
Maximum Mark: 75
Published
This mark scheme is published as an aid to teachers and candidates, to indicate the requirements of the
examination. It shows the basis on which Examiners were instructed to award marks. It does not indicate the
details of the discussions that took place at an Examiners’ meeting before marking began, which would have
considered the acceptability of alternative answers.
Mark schemes should be read in conjunction with the question paper and the Principal Examiner Report for
Teachers.
Cambridge International will not enter into discussions about these mark schemes.
Cambridge International is publishing the mark schemes for the May/June 2022 series for most
Cambridge IGCSE, Cambridge International A and AS Level and Cambridge Pre-U components, and some
Cambridge O Level components.
These general marking principles must be applied by all examiners when marking candidate answers. They should be applied alongside the specific content of the
mark scheme or generic level descriptors for a question. Each question paper and mark scheme will also comply with these marking principles.
1 Unless a particular method has been specified in the question, full marks may be awarded for any correct method. However, if a calculation is required then
no marks will be awarded for a scale drawing.
2 Unless specified in the question, answers may be given as fractions, decimals or in standard form. Ignore superfluous zeros, provided that the degree of
accuracy is not affected.
3 Allow alternative conventions for notation if used consistently throughout the paper, e.g. commas being used as decimal points.
4 Unless otherwise indicated, marks once gained cannot subsequently be lost, e.g. wrong working following a correct form of answer is ignored (isw).
5 Where a candidate has misread a number in the question and used that value consistently throughout, provided that number does not alter the difficulty or
the method required, award all marks earned and deduct just 1 mark for the misread.
6 Recovery within working is allowed, e.g. a notation error in the working where the following line of working makes the candidate’s intent clear.
The following notes are intended to aid interpretation of mark schemes in general, but individual mark schemes may include marks awarded for specific reasons
outside the scope of these notes.
Types of mark
M Method mark, awarded for a valid method applied to the problem. Method marks are not lost for numerical errors, algebraic slips or errors in units.
However, it is not usually sufficient for a candidate just to indicate an intention of using some method or just to quote a formula; the formula or idea
must be applied to the specific problem in hand, e.g. by substituting the relevant quantities into the formula. Correct application of a formula
without the formula being quoted obviously earns the M mark and in some cases an M mark can be implied from a correct answer.
A Accuracy mark, awarded for a correct answer or intermediate step correctly obtained. Accuracy marks cannot be given unless the associated method
mark is earned (or implied).
DM or DB When a part of a question has two or more ‘method’ steps, the M marks are generally independent unless the scheme specifically says otherwise;
and similarly, when there are several B marks allocated. The notation DM or DB is used to indicate that a particular M or B mark is dependent on
an earlier M or B (asterisked) mark in the scheme. When two or more steps are run together by the candidate, the earlier marks are implied and full
credit is given.
FT Implies that the A or B mark indicated is allowed for work correctly following on from previously incorrect results. Otherwise, A or B marks are
given for correct work only.
A or B marks are given for correct work only (not for results obtained from incorrect working) unless follow through is allowed (see abbreviation FT above).
For a numerical answer, allow the A or B mark if the answer is correct to 3 significant figures or would be correct to 3 significant figures if rounded (1
decimal place for angles in degrees).
The total number of marks available for each question is shown at the bottom of the Marks column.
Wrong or missing units in an answer should not result in loss of marks unless the guidance indicates otherwise.
Square brackets [ ] around text or numbers show extra information not needed for the mark to be awarded.
AG Answer Given on the question paper (so extra checking is needed to ensure that the detailed working leading to the result is valid)
CAO Correct Answer Only (emphasising that no ‘follow through’ from a previous error is allowed)
SC Special Case (detailing the mark to be given for a specific wrong solution, or a case where some standard marking practice is to be varied in the
light of a particular circumstance)
1 1 3 B1 OE
4C1 p x soi Can be seen in an expansion.
p3
4 B1 OE
144 Correct with correct power of p and only one p term.
p2
1 B1 B1 2
p OE ± etc. Allow ±0.167 for B1 B1.
6 12
1
SC B1 for B1 only,
36
2(a) [p =] 3 B1
2(b) 1 B1
[q =]
2
2(c) [r =] ‒2 B1
3(b) 11726 *M1 OE Use of correct un formula with expression from (a) or
4 n 1 d 139 leading to 8 135 Sn formula to eliminate d.
n
11726 A1
n= = 82
143
5 A1 138
d Accept OE fraction only
3 81
If M0 DM0 scored them SC B1 B1 for correct n and d
values only.
4(a)
x 1 2
2 x 1 5 3 , or x 1 1 6 3
2 M1 M1 1
M1 for dealing with and M1 for dealing with
0
.
0 3
4(b) {Stretch}{x direction or horizontally or y-axis invariant}{ factor ½} B2, 1, 0 Additional transformation B0.
5(b) Use of tan x = their y values M1 Must have at least 2 values of y from part (a).
6(a)
2 x 4
2
9 B1 B1 OE When a and b stated give priority to marking
algebraic expression.
x9 A1 FT x b
[f 1 x ] 4 OE FT on their answer to (a) i.e. – a .
2 2
8 x 2 9 only A1
7(b) x 2 2 3x 4 20 *M1 OE
2 2
3 A1 3 13
Equation of tangent is y 5 x 1 WWW Or y x .
2 2 2
Or by 5dx .
1
Required area = 75 ‒ 66 = 9 A1
AC = 9.40 A1 SOI
Accept 9.39 – 9.41, may be used but not seen for A1.
Arc CD = their 9.40 their 0.6708 M1 Expect 6.306 (or 6.31), do not accept 6 for their AC or 1.8
for CAB.
9(b) Sector ADC ‒ ABC = ½ their 9.402 their 0.6708 – ½ 62 sin 1.8 M1 M1 Accept correct use of their answers from part (a).
10(b) dy
dx
2 4 x 2
3
4
B1 B1 Allow unsimplified forms.
dy B1 SOI
Recognise = ‒1
dx
8 M1 Must be numerical.
their their 1
dy
4x 23
Must be some attempt to solve their equation and 0.
dx
x 1 A1
2
0 x 1 only
m M1 A1 dy
2
m x2 1 Equating their and m and attempt to solve.
x dx
y m or (‒1, m) A1
11(b) 1 *M1 1
Equation of normal is y m x 1 Through their P with gradient , OE
m m
1 m2 1
e.g. y x .
m m
1
Allow use of the gradient of the curve as with
m
their x 2
their P.
Coordinates of P must be in terms of m only.
x 1 x m 2 0 x m2 A1 or
x
2 2
m 2 1 1 2m 2 m 4 4m 2 m 1 m 1
m2
2 2
m 1 A1 1
y or m2 , , ignore the coordinates of P.
m2 m m