Anderol Pqaa-2 Plus - Food Grase - 2

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

ANDEROL PQ AA 2 PLUS

Food-Grade
difficult Grease NLGI-2 Product Data Sheet
difficult

ANDEROL PQ AA 2 PLUS is an aluminum complex thickened grease designed for use in


food processing machinery. It is a non-toxic, general-purpose grease and can satisfy a wide
variety of applications. It provides excellent anti-wear protection and prevent corrosion.

ANDEROL PQ AA 2 PLUS has good water resistance. This product is NSF/H1 and InS/H1
registered for use in applications where incidental food contact can occur.

APPLICATIONS / ADVANTAGES REGISTRATIONS / APPROVAL HANDLING AND STORAGE

 Lubrication of friction bearings even at high ANDEROL PQ Food Grade lubricants are ANDEROL PQ Food Grade lubricants
temperatures and water exposure approved, recommended and field tested by generally present little hazard in normal
 General-purpose food grade grease many OEM’s in the food processing, bottling, handling if ordinary care is exercised. If
 Lubrication of machinery in food and canning, meat processing, and pharmaceutical spilled, cover with inert, absorbent material
beverage industry industries. and remove. Flush the area with water.
 Grease lubricated points in can seaming
and bottling ANDEROL and PQ Food Grade lubricants are Although PQ Food Grade lubricants are not
 Excellent wear protection registered by NSF International (www.nsf.org) highly flammable, they will burn and should
and meets USDA 1998 Guidelines. ANDEROL be kept away from open flames. In case of
 Prevents Rusting
Food Grade lubricants also meet the fire, use water spray, foam, carbon dioxide, or
 Good mechanical stability certification requirements recommended by the dry chemical.
National Lubricating Grease Institute (NLGI)
and the European Lubricating Grease Institute PQ Food Grade lubricants should be stored
(ELGI) preferably in protected locations to prevent
contamination. Do not re-use drums; flush
and send to re-conditioner.

PROPERTIES TEST METHOD ANDEROL PQ AA 2 PLUS


Thickener Al-complex
Color White
Type of Base Oil Med. White Oil (DAB10)
Operating temperature for long-term lubrication -20 to +140° C
Short time admissible temperature peak value +180° C
Dropping Point ASTM D-2265 >250° C
Worked Penetration ASTM D-217 265 to 295
Base Oil Viscosity at 40° C ASTM D-445 160 mm²/s
Water resistance DIN 51.807-01 0-90
Corrosion Protection IP 220/85 Corrosion degree 0/1
4-Ball-test welding load DIN 51.350 3200 N
Designation DIN 51.502 KP 2N-20

FOR MORE INFORMATION PLEASE REFER TO THE RELEVANT MATERIAL SAFETY DATA SHEET

APPROVALS / REGISTRATIONS
ANDEROL BV
Groot Egtenrayseweg 23
5928 PA VENLO
The NETHERLANDS
Tel No.: +31 (0)77 396 03 40
Fax No.: +31 (0)77 396 03 49
www.anderol-europe.com

This information is furnished without warranty, representation, inducement, or license of any kind except that it is accurate to the best of OUR knowledge or obtained from sources believed by
ANDEROL to be accurate. ANDEROL does not assume any legal responsibility for use of reliance upon it. Only Chemists or chemically qualified lab technicians should carry out tests. Before using any
chemicals, read its label and Material Safety Data Sheet.

You might also like