Cebex 200

Cebex® 200 constructive solutions
Plasticising and hydrogen free expansion grout

admixture
Uses Setting Time :Cebex 200 may slightly retard the setting times
of cement based grouts depending on the cement and
Cebex 200 is an admixture for cement grouts where a ambient temperature.
reduced water / cement ratio and positive expansion are Expansion characteristics :The controlled positive
required. Applications include bed grouting, duct grouting, expansion in unset grouts incorporating Cebex 200
non-shrink infilling and jointing. overcomes plastic settlement when measured in accordance
with ASTM C827. An unrestrained expansion of upto 2% is
Advantages
typical.
Time of expansion:15 minutes - 2 hours. Tempertures above

Hydrogen free expansion system compensates for plastic 200C may slightly reduce these times.
shrinkage and settlement in properly designed
cementitious grout. Compatibility : Cebex 200 is compatible with all types of
portland cement. Cebex 200 may be used in mixes containing
Reduced water / cement ratio in the grout mix ensures low
certain other Fosroc admixtures. Consult Fosroc for further
permeability and long term durability in service.
information.
Gives high grout fluidity with low water / cement ratio, thus
making placement or injection of the grout easy. Application instructions
No metallic iron content to corrode and cause staining or
deterioration due to rust expansion in the grout. Mixing
Composition allows high early strength development in For best results a mechanically powered grout mixer must be
grouts, without the use of chlorides. used. For quantities upto 50kg a slow speed drill fitted with a
high shear paddle is suitable. Larger quantities will require a
Description
high shear vane mixer. It is essential that machine mixing
capacity and labour availability is adequate to enable the
Cebex 200 a plasticising and hydrogen free expansion grout
grouting operation to be carried out continuously. This may
admixture is supplied as a powder admixture. Cebex 200
require the use of a holding tank with provision for gentle
allows the use of a reduced water / cement ratio with
agitation to maintain fluidity. The selected water content
consequent increased strengths and durability. The expansive
should be accurately measured into the mixer. Slowly add
medium counteracts the natural settlement and plastic
the cement and Cebex 200. Mix continuously for 5 minutes,
shrinkage of the grout and aids stability and cohesion.
making sure that a smooth even consistency is obtained.
Technical Support Application
Areas to be grouted should be prepared to ensure substrates

Fosroc offers a comprehensive range of high performance,
are clean, sound, and then pre-wetted. The unrestrained
high quality concrete repair and construction products. In
surface area of the grout must be kept to a minimum. Place
addition, Fosroc offers technical support service to specifiers,
the grout as early as possible after mixing to gain the full
end-users and contractors, as well as on-site technical
benefit of the expansion process. Adopt usual placing or
assistance in locations all over the country.
pumping procedures ensuring a continuous operation.
Properties
Curing
Chloride content : Nil to BS : 5075 On completion of the grouting operation, any exposed areas
which are not to be cut back should be thoroughly cured by
Compressive strength :The plasticising action of Cebex 200 means of water application, Concure curing membrane or
allows reduction of the water/cement ratio of cementitious wet Hessian.
grouts whilst maintaining flow properties. This gives
Cebex® 200
improvement in strength and long term durability when cured

under restraint.
Cebex® 200
Clean Effects of overdosing
Grouts mixed with Cebex 200 should be removed from tools Drastic overdosing of Cebex 200 increases expansion and
and equipment with clean water immediately after use. Cured may cause frothing.
material should be removed mechanically or with Reebaklens.
Storage
Limitations 6 months if kept in a dry store in its original packing. High

temperature and humidity storage may reduce this period.
Cebex 200 is incompatible with High Alumina Cement.
Required expansion may not be achieved, if grout is bleeding. Precautions
Estimating Health and Safety
Cebex 200 is of low hazard. Contact with the skin and eyes,
Packing
or inhalation of dust should be avoided. Suitable protective
Cebex 200 is supplied in 225 gm packs. clothing, gloves, eye/face protection and dust mask should
be worn. Any contact with skin, should be washed with clean
Dosage
water. Incase of contact with eyes, should be rinsed
immediately with plenty of water and sought medical
OPC Concreting Water Cebex 200 Approx. attention.
sand Yield
50kg - ** 225g 36 litres
50kg 50kg ** 225g 57 litres
** Best determined by site trials. As a guide suggested

W/P is 0.39 to 0.45.
Note : For grout, mortar or concrete mixes with an aggregate/

cement ratio more than 1, use 4 x 225g units of Cebex 200
per 100 kg of cement.
® Denotes the trademark of Fosroc International Limited

Important note :
Fosroc products are guaranteed against defective materials and manufacture and are sold subject
to its standard terms and conditions of sale, copies of which may be obtained on request. Whilst
Fosroc endeavours to ensure that any advice, recommendation specification or information it may
give is accurate and correct, it cannot, because it has no direct or continuous control over where
or how its products are applied, accept any liability either directly or indirectly arising from the
use of its products whether or not in accordance with any advice, specification, recommendation
Fosroc Chemicals (India) Pvt. Ltd. or information given by it.
Head Office telephone fax e-mail

111/3, Hafeeza Chamber II Floor,
++91 80-22240018/120 ++91 80-22233474 [email protected]
K H Road, PBNo. 2744, Bangalore 560027
www.fosroc.com
Regional Offices
Bangalore Mumbai Delhi Kolkata
Shankar House, IV Floor 208/209, Persepolis First floor,1/2 East Patel Nagar 30/B Jodhpur Park
1 & 18, RMV Extension Sector 17, Vashi Opp: Vivek Cinema, Main Patel Rd Ground Floor
Bangalore 560 080 Navi Mumbai 400 703 New Delhi 110 008 Kolkata 700 068
Ph:080-2361 3161/2361 2004 Ph:022-2789 6412/14 Ph:011-25884903/4 Ph: 033 2472 5482
Fax : 080-2361 7454 Fax: 022 - 2789 6413 Fax: 011- 25884422 Fax: 033-2472 9921
email: [email protected] email:[email protected] email:[email protected] email:[email protected]
Ahmedabad : (079) 26762799 Ankleshwar :(02646) 220704/224687 Bhubaneshwar : (0674) 2521176 Chennai (044) 24899949/24853383
Chandigarh : (0172) 2639360 Cochin : (0484) 2356668 Coimbatore : (0422) 2472966 Goa : (0832) 2542465 Guwahati (0361) 2548793
Hyderabad : (040) 27662324/27662425 Hubli (0836) 3402597 Indore : (0731) 504339/5061477 Jaipur : (0141) 2235349 Lucknow :(0522)
22239044 Nagercoil (04652) 2224849 Mangalore: (0824) 22272234 Visakhapatnam : (0891) 2564850 INDIA/2004/0328/D

Cebex 200

Uploaded by

Copyright:

Available Formats

Cebex 200

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Cebex 200

Uploaded by

Copyright:

Available Formats

Cebex® 200 constructive solutions

Plasticising and hydrogen free expansion grout

Time of expansion:15 minutes - 2 hours. Tempertures above

Areas to be grouted should be prepared to ensure substrates

improvement in strength and long term durability when cured

Clean Effects of overdosing

Limitations 6 months if kept in a dry store in its original packing. High

Estimating Health and Safety

50kg - ** 225g 36 litres

50kg 50kg ** 225g 57 litres

** Best determined by site trials. As a guide suggested

Note : For grout, mortar or concrete mixes with an aggregate/

® Denotes the trademark of Fosroc International Limited

Head Office telephone fax e-mail

You might also like