SUNPOWER Sp-Oasis-Datasheet-Rv2 - 0
SUNPOWER Sp-Oasis-Datasheet-Rv2 - 0
SUNPOWER Sp-Oasis-Datasheet-Rv2 - 0
Faster Commissioning
Pre-manufactured tracker and electrical
systems ensure the plant is quickly
permitted, constructed, and connected
to the grid.
Reliable technology with an unparalleled efficient installation with the Oasis. Each Oasis C1 1.5 MW power block
track record minimises risk and ensures features SunPower high-efficiency solar panels2 mounted on proprietary
Data Sheet
Oasis™ C1 | Power Plant
Typical Power Block Configuration
Inverter Station Rating 1.50 MWac
Total DC Panel Capacity 1.88 MWdc
DC/AC Ratio 1.25
Panels per Power Block 4,320
Strings per Power Block 432
Combiner Boxes per
18
Power Block
Trackers per Power Block 6
C1 Tracker System
Horizontal single-axis, astronomical
Tracking Type
algorithm with backtracking
Tracking Range +45 to –45 degrees
One electric linear actuator per tracker, with
Drive System
TMAC™ tracker controller
Ground Coverage Ratio (GCR) 0.35 to 0.45
Foundations Galvanised steel driven piles
Structural Components Galvanised steel
Tracker Bearings Maintenance free polymer journal bearings
Certifications UL
DC Electrical System
PV Panels E20™ 435 W commer cial panel
Standard 24-string combiner box with load-
DC Combiner Boxes break disconnect and pre-manufactured
array wiring harness
DC Feeder Conductor Aluminum, direct burial
Maximum DC System Voltage 1000 V
Certifications UL
Inverter Station
Total Power Rating 1.50 MWac at inverter terminals, for p.f.=1
Power Factor Range 0.9 leading to 0.9 lagging
Maximum DC Voltage 1000 V
Maximum Inverter THD <3%
Weighted Inverter Efficiency ≥97.5%
Inverter Enclosure IP54
Voltage & frequency ride-through per IEEE,
FERC and WECC standards. Power factor
Utility Interconnection control, power curtailment and other grid
support functions available with SunPower™
Grid Controller
4 kV to 35 kV, configured per interconnection
Transformer Voltage
requirement
Transformer Efficiency 99%, operating load weighted
Certifications UL
Site Conditions
Maximum Wind Speed 100 mph, 3 sec gust
Maximum Snow Load 20 psf
Ground Slope Tolerance Up to 6 degrees in any direction
Flood Clearance for 12” sheet flow standard
Maximum Corrosion ISO category 3 environ ments
Operating Ambient Temperature -4°F to 122°F (-20°C to 50°C)
Elevation Up to 3,280’ (1000m) without de-rating
Humidity 15% to 95%, non-con densing
© 2014 SunPower Corporation. All rights reserved. SUNPOWER, the SUNPOWER logo, OASIS, and TMAC are trademarks or registered trademarks of SunPower Corporation
in the U.S. and other countries as well. Specifications included in this datasheet are subject to change without notice.
Data Sheet