Scribd
Upload
1K views

PMI Error Codes

The document provides a display code guide for error codes shown on the PMI-DAU device. The codes are shown as two digits with the first digit indicating the device mode and the second digit specific warnings or errors. Errors range from hardware issues to software exceptions to triggers and data overloads. Resolving the issue typically involves resetting or replacing the unit, reconnecting cables, or checking power supply lines.

Uploaded by

Laurian Chirtop
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views

PMI Error Codes

The document provides a display code guide for error codes shown on the PMI-DAU device. The codes are shown as two digits with the first digit indicating the device mode and the second digit specific warnings or errors. Errors range from hardware issues to software exceptions to triggers and data overloads. Resolving the issue typically involves resetting or replacing the unit, reconnecting cables, or checking power supply lines.

Uploaded by

Laurian Chirtop
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DISPLAY CODES FOR THE PMI-DAU

Both Digits: Blocking startup errors


Display Type Description Action
 HW Error A hardware error exists Reset/Replace Unit
IDKey IDKey is not connected or Reconnect/replace
2nd Digit: Warnings and errors

Error invalid IDKey Display Description Action
Recovered from fatal Check power
 SW Error exception
Reset/Reload App  Main supply line A missing
supply line A
 Check power
Main supply line B missing
supply line B
Overload on supply to isolated
 analog input
Overload on supply to non-
 isolated analog input

 Overload on supply to digital I/O

 Internal power monitor failed Reset/Replace Unit


Trigger or TDC timeout: Engine is

 
stopped or running at a very low
speed
Direction change: Engine is
 reversing
Too many trigger pulses: System is
 incorrectly configured or engine
is reversing
1st Digit: Modes  Data overload: The system is
experiencing data overload –
Display Description possible causes: noise on trigger
signals
 Bootloader Mode  Trigger inconsistency: Different
no. of trigger pulses per revolution
 Test Mode detected – bad encoder setup
or adjustment
 Configuration Mode
 Missing configuration: PMI-DAU
has not been configured with
 Normal Mode engine parameters
Invalid direction: Engine is running
 Running/calculating  astern

3092551-9.2

You might also like