0% found this document useful (0 votes)
63 views4 pages

RC Exam Elec 4

The document contains questions about electronics topics such as rectifiers, capacitors, filters, transistors, diodes, and electric fields. It tests knowledge of concepts like the Q-point of an amplifier, output characteristics of FETs and valves, properties of mica capacitors, induced magnetic fields, capacitor combinations, damping coefficients, ripple voltage, bridge and center-tap rectifiers, resistor values in circuits, diode states, ladder circuits, resonant frequencies, and more. The document contains the questions, circuit diagrams where relevant, and space for solutions to calculate values.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
63 views4 pages

RC Exam Elec 4

The document contains questions about electronics topics such as rectifiers, capacitors, filters, transistors, diodes, and electric fields. It tests knowledge of concepts like the Q-point of an amplifier, output characteristics of FETs and valves, properties of mica capacitors, induced magnetic fields, capacitor combinations, damping coefficients, ripple voltage, bridge and center-tap rectifiers, resistor values in circuits, diode states, ladder circuits, resonant frequencies, and more. The document contains the questions, circuit diagrams where relevant, and space for solutions to calculate values.
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

1 Which of the following statements is false?

A rectifier changes
d.c. to a.c
2 What is the best location for setting a Q-point on dc load line of an FET amplifier? At mid-point

3 The output characteristics of a FET closely resemble the output characteristic of a pentode
_________valve.

4 What capacitor has a low temperature coefficient of capacitance and good stability Mica
with temperature and frequency making this a good choice for critical precision
circuitry such as filter applications?

5 As an externally generated magnetic field through a certain conducting loop increases directed opposite to
in magnitude, the field produced at points inside the loop by the current induced in the the applied field
loop must be:

6 If both the plate area and the plate separation of a parallel-plate capacitor are unchanged
doubled, the capacitance is:

7 The capacitors C₁, C₃, C₄ and C₅ have a 4 μF


capacitance of 4 μF each and the capacitor
C₂ has a capacitance of 10 μF. What will be the
effective capacitance (in μF) between the points
X and Y?

Solution:

8 What is the damping coefficient for the given 1/2


circuit below?

9 The small variation  in the output voltage of a dc power supply is called _____.  ripple voltage

10 The figure below shows a center-tap circuit having the load resistance and 20.7 V
transformer turn ratio given. The primary is connected to 230 V, 50 Hz supply.  Find
the d.c. output voltage.
Solution:

11 The JFET in the circuit shown in figure has an I_DSS = 156 Ω


10 mA and Vp = -5 V. What is the value of the resistance
Rs for a drain current I_DS = 6.4 mA?

12 In the circuit shown in the given figure, the diode states at the extremely large D₁ on, D₂ off
negative values of the input voltage vi are:

13 In the infinite ladder circuit as shown 1.61r


above each resistance of r Ω then find
R_AB.

Solution:

14 When a diode in a center –tapped rectifier opens, the output is half-wave rectifier
15 In the experiment shown:  there is a current in
G just after S is
opened or closed

16 What is the resonant frequency of the circuit shown in 1/4pi Hz


the figure?

17 What resistor type is unsuited for use above 50 kHz? Wirewound resistor

18 The bridge rectifier shown below uses 9.91 V; 825.8 μA


silicon diodes. Find the d.c. output
voltage and d.c. output current. Use
simplified model for the diodes

Solution:

19 The process of changing a half-wave rectified voltage to a constant voltage is called filtering
____.

20 In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the - 60


capacitance are very large. What is approximately the mid-band voltage gain of the
amplifier?
21 Find the voltage across 64 Ω resistor for the circuit shown below. 64/63 V

Solution:

22 As an externally generated magnetic field through a certain conducting loop increases directed opposite to
in magnitude, the field produced at points inside the loop by the current induced in the the applied field
loop must be:

23 During the positive half-cycle of the input voltage in a bridge rectifier, two diodes are
forward-biased
24 The surface charge density on a conductor is 1.55 x 10¯⁹ C/m². The conductor is 2.25 V/m
immersed in water with ε = 78ε_0. What will be the electric field?

Solution:

25 Reverse saturation current in a silicon PN junction diode nearly doubles for every 100ᵒ
____ degree rise in temperature.

You might also like